Please wait a minute...
金属学报  1992, Vol. 28 Issue (1): 16-20    
  论文 本期目录 | 过刊浏览 |
Fe-C-Mn-B合金奥氏体等温分解动力学及Mn的再分配
杨柳;方鸿生;孟至和
西南交通大学;清华大学;洛阳工学院
KINETICS OF AUSTENITIC ISOTHERMAL DECOMPOSITION AND Mn PARTITION IN Fe-C-Mn-B ALLOYS
YANG Liu;FANG Hongsheng;MENG Zhihe Southwestern Jiaotong university; Chengdu; Tsinghua University; Beijing; Luoyang Institute of Technology
引用本文:

杨柳;方鸿生;孟至和. Fe-C-Mn-B合金奥氏体等温分解动力学及Mn的再分配[J]. 金属学报, 1992, 28(1): 16-20.
, , . KINETICS OF AUSTENITIC ISOTHERMAL DECOMPOSITION AND Mn PARTITION IN Fe-C-Mn-B ALLOYS[J]. Acta Metall Sin, 1992, 28(1): 16-20.

全文: PDF(492 KB)  
摘要: 测定了不同含Mn量的Fe—C—Mn—B系合金的等温转变TTT曲线,结果表明,适量Mn加入Fe—C合金不但推迟转变,而且使TTT曲线形状发生较大改变而出现河湾形状。用能谱分析方法测定Mn在奥氏体、铁素体及相界处的分布规律表明,随转变温度的降低,Mn由再分配向无再分配转化,在其间存在一个温度范围、虽然无两相间的再分配,但在相界处有明显的Mn浓度峰,而且浓度峰最强的温度与TTT曲线上河湾温度相对应。说明TTT曲线形状的改变与合金元素再分配规律变化有关,河湾的出现归因于Mn在相界富集而产生的溶质拖曳与溶质类拖曳作用。
关键词 TTT曲线再分配溶质拖曳MnFe-C合金    
Abstract:A proper addition of Mn to Fe--C alloys could delay the isothermal transforma-tion and change the shape of the TTT curves of the alloys. The concentration of Mn at α/γ in-terfaces and their neighboring matrix were measured by STEM / EDAX. The results show that the partition of Mn between α and γ occurs at higher temperature but not at lower temperature. There exists certain temperature range with the strongest Mn concentration spike at the inter-face even though Mn partition between α and γ is not found at the temperature on range. The fact that temperature at which the highest Mn concentration spike occurs is correspondent with the bay temperature on TTT curves shows that the change of TTT curve shape is due to the solute drag effect and solute drag--like effect which are caused by the enrichment of Mn at the α/γ interface.
Key wordsTTT curve    partition    Mn    Fe-C alloy    solute drag
收稿日期: 1992-01-18     
1 Coates D E. Metall Trans, 1973; 4A: 2313
2 Hillert M. Internal Report, Swedish Institute Metal research, 1953
3 Kirkaldy J S. Can J Phys, 1958; 36: 907
4 Purdy G R, Weichert D H, Kirkaldy J S. Trans Metall Soc AIME, 1964; 230: 1025
5 Hultgren A. Trans ASM, 1947; 39: 915
6 Darken L S. Trans Metall Soc AIME, 1961; 221: 654
7 Aaronson H I, Domian H A. Trans Metall Soc AIME, 1966; 236: 781
8 Gilmour J B, Purdy G R, Kirkaldy J S. Metall Trans, 1972; 3A: 3213
9 Romig A D Jr., Salzbrenner R. Scr Metall, 1982; 16: 33
10 Enomoto M, Aaronson HI. Metall Trans, 1987; 18A: 1547
11 杨柳,方鸿生,陈南平.清华大学学报(自然科学版),1988;28(2) :93
12 Balluffi R W. In: Johnson W C, Blakely J M eds., Interfacial Segregation, Metals Park, Ohio: ASM, 1979: 193
13 Bradley J R, Aaronson H I. Metall Trams, 1981; 12A: 1729
14 Kinsman K R, Aaronson H I. Transformation and hardenability in Steels, Symposium, Ann Arbor, Michigan: Climax Molybdenum Company of Michigan, 1977: 3
[1] 丁桦, 张宇, 蔡明晖, 唐正友. 奥氏体基Fe-Mn-Al-C轻质钢的研究进展[J]. 金属学报, 2023, 59(8): 1027-1041.
[2] 李小涵, 曹公望, 郭明晓, 彭云超, 马凯军, 王振尧. 低碳钢Q235、管线钢L415和压力容器钢16MnNi在湛江高湿高辐照海洋工业大气环境下的初期腐蚀行为[J]. 金属学报, 2023, 59(7): 884-892.
[3] 程远遥, 赵刚, 许德明, 毛新平, 李光强. 奥氏体化温度对Si-Mn钢热轧板淬火-配分处理后显微组织和力学性能的影响[J]. 金属学报, 2023, 59(3): 413-423.
[4] 韩冬, 张炎杰, 李小武. 短程有序对高层错能Cu-Mn合金拉-拉疲劳变形行为及损伤机制的影响[J]. 金属学报, 2022, 58(9): 1208-1220.
[5] 耿遥祥, 唐浩, 许俊华, 张志杰, 喻利花, 鞠洪博, 江乐, 简江林. 选区激光熔化高强Al-(Mn, Mg)-(Sc, Zr)合金成形性及力学性能[J]. 金属学报, 2022, 58(8): 1044-1054.
[6] 任平, 陈兴品, 王存宇, 俞峰, 曹文全. 预变形和双级时效对Fe-30Mn-11Al-1.2C奥氏体低密度钢显微组织和力学性能的影响[J]. 金属学报, 2022, 58(6): 771-780.
[7] 孙毅, 郑沁园, 胡宝佳, 王平, 郑成武, 李殿中. 3Mn-0.2C中锰钢形变诱导铁素体动态相变机理[J]. 金属学报, 2022, 58(5): 649-659.
[8] 王世宏, 李健, 柴锋, 罗小兵, 杨才福, 苏航. 固溶温度对Fe-19Mn合金的γε相变和阻尼性能的影响[J]. 金属学报, 2020, 56(9): 1217-1226.
[9] 邓亚辉, 杨银辉, 蒲超博, 倪珂, 潘晓宇. Mn23%CrNi型双相不锈钢高温拉伸行为的影响[J]. 金属学报, 2020, 56(7): 949-959.
[10] 姚小飞, 魏敬鹏, 吕煜坤, 李田野. (CoCrFeMnNi)97.02Mo2.98高熵合金σ相析出演变及力学性能[J]. 金属学报, 2020, 56(5): 769-775.
[11] 陈兴品,李文佳,任平,曹文全,刘庆. C含量对Fe-Mn-Al-C低密度钢组织和性能的影响[J]. 金属学报, 2019, 55(8): 951-957.
[12] 黄森森,马英杰,张仕林,齐敏,雷家峰,宗亚平,杨锐. α+β两相钛合金元素再分配行为及其对显微组织和力学性能的影响[J]. 金属学报, 2019, 55(6): 741-750.
[13] 田亚强,田耕,郑小平,陈连生,徐勇,张士宏. 淬火配分贝氏体钢不同位置残余奥氏体C、Mn元素表征及其稳定性[J]. 金属学报, 2019, 55(3): 332-340.
[14] 白静, 石少锋, 王锦龙, 王帅, 赵骧. Ni-Mn-Ga-Ti铁磁形状记忆合金的相稳定性和磁性能的第一性原理计算[J]. 金属学报, 2019, 55(3): 369-375.
[15] 陈雷, 郝硕, 邹宗园, 韩舒婷, 张荣强, 郭宝峰. TRIP型双相不锈钢Fe-19.6Cr-2Ni-2.9Mn-1.6Si在循环变形条件下的力学特性[J]. 金属学报, 2019, 55(12): 1495-1502.