Please wait a minute...
金属学报  2013, Vol. 49 Issue (11): 1369-1373    DOI: 10.3724/SP.J.1037.2013.00394
  论文 本期目录 | 过刊浏览 |
Er高Nb TiAl基合金抗循环氧化性能研究
宫子琪,陈子勇,柴丽华,相志磊,聂祚仁
北京工业大学材料科学与工程学院, 北京 100124
STUDY ON CYCLIC OXIDATION RESISTANCE OF  HIGH NIOBIUM CONTAINING TiAl BASE ALLOY WITH ERBIUM
GONG Ziqi, CHEN Ziyong, CHAI Lihua, XIANG Zhilei, NIE Zuoren
Department of Materials Science and Engineering, Beijing University of Technology, Beijing 100124
引用本文:

宫子琪,陈子勇,柴丽华,相志磊,聂祚仁. 含Er高Nb TiAl基合金抗循环氧化性能研究[J]. 金属学报, 2013, 49(11): 1369-1373.
GONG Ziqi, CHEN Ziyong, CHAI Lihua, XIANG Zhilei, NIE Zuoren. STUDY ON CYCLIC OXIDATION RESISTANCE OF  HIGH NIOBIUM CONTAINING TiAl BASE ALLOY WITH ERBIUM[J]. Acta Metall Sin, 2013, 49(11): 1369-1373.

全文: PDF(1130 KB)  
摘要: 

采用水冷Cu坩埚真空感应悬浮熔炼技术制备了Ti-46Al-8Nb和Ti-46Al-8Nb-0.1Er合金.根据氧化动力学, 结合XRD, SEM和EDS分析氧化层的相结构、显微组织及与基体合金的界面特征,测试了合金在900℃的抗循环氧化性能. 结果表明, 2种合金循环氧化100 h, 100 cyc均未见氧化膜剥落,Ti-46Al-8Nb-0.1Er较Ti-46Al-8Nb表现出更优良的抗氧化性能,氧化后第二层混合氧化物主要由Al2O3组成,连续致密且与基体良好结合的氧化膜可明显降低合金的氧化速率、减小氧化增重及氧化膜厚度.Er净化了合金基体, 阻止O原子内向扩散,并促进TiAl氧化膜中的Al2O3形成, 从而提高TiAl基合金的抗循环氧化性能.

关键词 TiAl循环氧化Er氧化层    
Abstract

Ti-46Al-8Nb and Ti-46Al-8Nb-0.1Er alloys were prepared by the cold crucible induction levitation melting method. The oxidation behavior experiment was done in air at 900℃ up to one hundred times. Based on the oxidation kinetic analysis and the phase constitution, microstructure and the interface of the oxidation film and the matrix were investigated by means of XRD and SEM equipped with EDS, the cyclic oxidation resistance of TiAl based alloys was explored. The results showed that no spallation of layer occurs in both alloys, and Ti-46Al-8Nb-0.1Er comparing with Ti-46Al-8Nb exhibits more excellent oxidation resistance, oxides formed on the surface consist of mainly Al2O3, the continuous compact oxidation film with a good combination with the matrix significantly decreases the oxidation rate, the mass gain and the oxide film thickness. The addition Er purifies the alloy matrix and prevents the inward diffusion of oxygen atoms, thereby improves the cyclic oxidation resistance of TiAl based alloy.

Key wordsTiAl    cyclic oxidation    Er    oxide layer
收稿日期: 2013-07-10     
基金资助:

北京市教委高层次人才培养项目00900054R8002和北京工业大学博士科研启动基金项目009000543113527资助

作者简介: 宫子琪, 男, 1987年生, 博士生

[1] Djanarthany S, Viala J C, Bouix J.  Mater Chem Phys, 2001; 72: 301

[2] Wu X H.  Intermetallics, 2006; 14: 1114
[3] Kim Y W.  JOM, 1994; 46(7): 30
[4] Dimiduk D M.  Mater Sci Eng, 1999; A263: 281
[5] Yang M R, Wu S K.  Acta Mater, 2002; 50: 691
[6] Xin L, Shao G, Wang F, Tsakiropoulos P, Li T.  Intermetallics, 2003; 11: 651
[7] Nishimoto T, Izumi T, Hayashi S, Narita T.  Intermetallics, 2003; 11: 225
[8] Sun J, Wu J S, Zhao B, Wang F.  Mater Sci Eng, 2002; A329-331: 713
[9] Perez P, Jimenez J A, Frommeyer G, Adeva P.  Mater Sci Eng, 2000; A284: 138
[10] Leyens C, Peters M, translated by Chen Z H.  Titanium and Titanium Alloys.Beijing: Chemical Industry Press, 2005: 183
(Leyens C, Peters M著, 陈振华~译. 钛与钛合金. 北京: 化学工业出版社, 2005: 183)
[11] Zhao L L, Lin J P, Wang Y L, Ye F, Chen G L.  Acta Metall Sin, 2008; 44: 557
(赵丽利, 林均品, 王艳丽, 叶丰, 陈国良. 金属学报, 2008; 44: 557)
[12] He S F, Lin J P, Xu X J, Gao J F, Wang Y L, Song X P, Chen G L.  Rare Met Mater Eng,2006; 35: 257
(何素芳, 林均品, 徐向俊, 高建峰, 王艳丽, 宋西平, 陈国良. 稀有金属材料与工程, 2006; 35: 257)
[13] Lin J P, Zhao L L, Li G Y, Zhang L Q, Song X P, Ye F, Chen G L.Intermetallics, 2011; 19: 131
[14] Wu Y, Hagihara K, Umakoshi Y.  Intermetallics, 2004; 12: 519
[15] Zhu Y M.  Master Thesis, Harbin Institute of Technology, 2011
(朱燕敏. 哈尔滨工业大学硕士学位论文, 2011)
[16] Li B H.  PhD Dissertation, Harbin Institute of Technology, 2007
(李宝辉. 哈尔滨工业大学博士学位论文, 2007)
[17] Lu X, He X B, Zhang B, Qu X H, Zhang L, Guo Z X, Tian J J.  J Alloys Compd, 2009; 478: 220
[18] Zhao L L, Li G Y, Zhang L Q, Lin J P, Song X P, Ye F, Chen G L.Intermetallics, 2010; 18: 1586
[19] Zhao B, Wu J S, Sun J, Tu B J, Wang F.  Mater Lett, 2002; 56: 533
[20] Zhang X Y.  Practical Manual of Chemical. Beijing : National Defence Industry Press, 1986: 232
(张向宇. 实用化学手册. 北京: 国防工业出版社, 1986: 232)
[21] Perez P, Jimenez J A, Frommeyer G, Adeva P.  Mater Sci Eng, 2000; A284: 138
[22] Yang R, Cui Y Y, Dong L M, Jia Q.  J Mater Process Technol, 2003; 135: 179

[23] Yoshihara M, Miura K.  Intermetallics, 1995; 3: 357

[1] 黄鼎, 乔岩欣, 杨兰兰, 王金龙, 陈明辉, 朱圣龙, 王福会. 基体表面喷丸处理对纳米晶涂层循环氧化行为的影响[J]. 金属学报, 2023, 59(5): 668-678.
[2] 王虎, 赵琳, 彭云, 蔡啸涛, 田志凌. 激光熔化沉积TiB2 增强TiAl基合金涂层的组织及力学性能[J]. 金属学报, 2023, 59(2): 226-236.
[3] 娄峰, 刘轲, 刘金学, 董含武, 李淑波, 杜文博. 轧制态Mg-xZn-0.5Er合金板材组织及室温成形性能[J]. 金属学报, 2023, 59(11): 1439-1447.
[4] 李小兵, 潜坤, 舒磊, 张孟殊, 张金虎, 陈波, 刘奎. W含量对Ti-42Al-5Mn-xW合金相转变行为的影响[J]. 金属学报, 2023, 59(10): 1401-1410.
[5] 沈莹莹, 张国兴, 贾清, 王玉敏, 崔玉友, 杨锐. SiCf/TiAl复合材料界面反应及热稳定性[J]. 金属学报, 2022, 58(9): 1150-1158.
[6] 杨天野, 崔丽, 贺定勇, 黄晖. 选区激光熔化AlSi10Mg-Er-Zr合金微观组织及力学性能强化[J]. 金属学报, 2022, 58(9): 1108-1117.
[7] 陈玉勇, 叶园, 孙剑飞. TiAl合金板材轧制研究现状[J]. 金属学报, 2022, 58(8): 965-978.
[8] 刘仁慈, 王鹏, 曹如心, 倪明杰, 刘冬, 崔玉友, 杨锐. 700℃热暴露对 β 凝固 γ-TiAl合金表面组织及形貌的影响[J]. 金属学报, 2022, 58(8): 1003-1012.
[9] 丁宁, 王云峰, 刘轲, 朱训明, 李淑波, 杜文博. 高应变速率多向锻造Mg-8Gd-1Er-0.5Zr合金的微观组织、织构及力学性能[J]. 金属学报, 2021, 57(8): 1000-1008.
[10] 姜江, 郝世杰, 姜大强, 郭方敏, 任洋, 崔立山. NiTi-NbTi原位复合材料的Lüders带型变形和载荷转移行为[J]. 金属学报, 2021, 57(7): 921-927.
[11] 刘冠熙, 黄光宏, 罗学昆, 申造宇, 何利民, 李建平, 牟仁德. 表面喷丸处理对NiCrAlYSi涂层恒温氧化行为的影响[J]. 金属学报, 2021, 57(5): 684-692.
[12] 蔡来强, 王旭东, 姚曼, 刘宇. 连铸圆坯非均匀传热/凝固行为的无网格计算方法[J]. 金属学报, 2020, 56(8): 1165-1174.
[13] 李天瑞, 刘国怀, 于少霞, 王文娟, 张风奕, 彭全义, 王昭东. 直接包套轧制铸态Ti-46Al-8Nb合金的组织特征及热变形机制[J]. 金属学报, 2020, 56(8): 1091-1102.
[14] 刘先锋, 刘冬, 刘仁慈, 崔玉友, 杨锐. Ti-43.5Al-4Nb-1Mo-0.1B合金的包套热挤压组织与拉伸性能[J]. 金属学报, 2020, 56(7): 979-987.
[15] 王希,刘仁慈,曹如心,贾清,崔玉友,杨锐. 冷却速率对β凝固γ-TiAl合金硼化物和室温拉伸性能的影响[J]. 金属学报, 2020, 56(2): 203-211.