Please wait a minute...
金属学报  2004, Vol. 40 Issue (5): 494-498     
  论文 本期目录 | 过刊浏览 |
定向凝固NiAl-15Cr合金的微观组织与超塑性变形行为
郭建亭;张光业; 周 健
中国科学院金属研究所;沈阳 110016
Microstructure and Superplastic Deformation Behavior of NiAl-15Cr Alloy
GUO Jianting; ZHANG Guangye; ZHOU Jian
Institute of Metal Research; The Chinese Academy of Sciences; Shenyang 110016
引用本文:

郭建亭; 张光业; 周健 . 定向凝固NiAl-15Cr合金的微观组织与超塑性变形行为[J]. 金属学报, 2004, 40(5): 494-498 .
, , . Microstructure and Superplastic Deformation Behavior of NiAl-15Cr Alloy[J]. Acta Metall Sin, 2004, 40(5): 494-498 .

全文: PDF(8255 KB)  
摘要: 研究了定向凝固NiAl-15Cr合金的显微组织和高温拉伸变形行为. 结果表明: 定向凝 固Ni-25Al-15Cr合金由β-NiAl枝晶干、γ/γ' 枝晶间相和γ' 过渡层组成. 合金在1123--1373 K、 初始应变速率为1.67×10 -4--1.67×10 -2 s-1 的条件下表现出超塑性变形行为. 在1323 K和 初始应变速率为8.35×10 -3 s-1 条件下获得的最大延伸率为280%, 应变敏感指数m为0.22. 通过变形过程中显微组织观察, 对其超塑性变形行为的机理进行了初步的讨论.
关键词 定向凝固NiAl基金属间化合物超塑性     
Abstract:The microstructure and deformation behavior of high temperature tension of a directionally solidified (DS) NiAl-15Cr alloy have been investigated. The results reveal that the microstructure consists of dendritic β-NiAl phase, interdendritic γ/γ' phase and transient layer γ' phase. The alloy shows superplastic behavior when it is deformed under the conditions of temperature range of 1123--1373 K and initial strain rate range of 1.67×10 -4--1.67×10 -2 s-1. The maximum elongation of 280% with m=0.22 is obtained at 1323 K and an initial strain rate of 8.35×10 -3 s-1. The superplastic mechanism for the alloy is also discussed by the observation of the microstructures evolution during the superplastic deformation process.
Key wordsdirectional solidification    NiAl--based intermetallics    superplasticity
收稿日期: 2003-05-16     
ZTFLH:  TG135.3  
[1] Sherby O D, Wadsworth J. Prog Mater Sci, 1989; 33:169
[2] Takasugi T, Rikukawa S, Hanada S T. Scr Metall Mater, 1991; 25:889
[3] Kirn M S, Hanada S, Wantanade S. Mater Trans JIM, 1989; 30(1) : 77
[4] Kim W Y, Hanada S, Sakai T. Acta Matrer, 1999; 46: 3593
[5] Chouhury A, Mukurjee A K, Sikka V K. Mater Sci, 1990; 25:3142
[6] Li D Q, Shan A D, Li Y, Lin D L. Scr Metall Mater; 1995; 33:681
[7] Lin D L, Li D Q, Liu Y. Intermetallics, 1998; 6:243
[8] Dutta A, Banerjee D. Scr Metall Mater, 1990; 24:1319
[9] Imayer R M, Kaibyshe O A, Salishcher G A. Acta Metal Mater, 1992; 40:581
[10] Yang H S, Jin P, Muhkerjee A K. Mater Sci Eng, 1992; 153:457
[11] Wang B, Jia T C, Zou D X. Mater Sci Eng, 1992; A152: 317
[12] Kim H Y, Hong S H. Scr Mater, 1998; 38:1517
[13] Du X H, Guo J T, Zhou B D. Scr Mater, 2001; 45:89
[14] Zhou W L, Guo J T, Chen R S, Li G S, Zhou J Y. Mater Lett, 2001; 47:30
[15] Zhou W L, Guo J T, Chen R S, Zhou J Y. Mater Lett, 2001; 51:342
[16] Du X H, Guo J T, Zhou B D. Mater Lett, 2002; 52:442
[17] Chen R S, Guo J T, Yin W M, Zhou J Y. Scr Mater, 1999; 40:219
[18] Noebe R D, Cullers C I.J Mater Res, 1992; 7:604
[19] Uan J Y, Chen L H, Liu T S. Metall Mater Trans, 1997; 28A: 401
[20] Qi Y H, Guo J T, Cui C Y. Chin J Nonferrous Met, 2002; 12:169(齐义辉,郭建亭,崔传勇.中国有色金属学报,2002;12:169)
[1] 马德新, 赵运兴, 徐维台, 王富. 重力对高温合金定向凝固组织的影响[J]. 金属学报, 2023, 59(9): 1279-1290.
[2] 张健, 王莉, 谢光, 王栋, 申健, 卢玉章, 黄亚奇, 李亚微. 镍基单晶高温合金的研发进展[J]. 金属学报, 2023, 59(9): 1109-1124.
[3] 苏震奇, 张丛江, 袁笑坦, 胡兴金, 芦可可, 任维丽, 丁彪, 郑天祥, 沈喆, 钟云波, 王晖, 王秋良. 纵向静磁场下单晶高温合金定向凝固籽晶回熔界面杂晶的形成与演化[J]. 金属学报, 2023, 59(12): 1568-1580.
[4] 李彦强, 赵九洲, 江鸿翔, 何杰. Pb-Al合金定向凝固组织形成过程[J]. 金属学报, 2022, 58(8): 1072-1082.
[5] 陈瑞润, 陈德志, 王琪, 王墅, 周哲丞, 丁宏升, 傅恒志. Nb-Si基超高温合金及其定向凝固工艺的研究进展[J]. 金属学报, 2021, 57(9): 1141-1154.
[6] 王慧远, 夏楠, 布如宇, 王珵, 查敏, 杨治政. 低合金化高性能变形镁合金研究现状及展望[J]. 金属学报, 2021, 57(11): 1429-1437.
[7] 张小丽, 冯丽, 杨彦红, 周亦胄, 刘贵群. 二次枝晶取向对镍基高温合金晶粒竞争生长行为的影响[J]. 金属学报, 2020, 56(7): 969-978.
[8] 许庆彦,杨聪,闫学伟,柳百成. 高温合金涡轮叶片定向凝固过程数值模拟研究进展[J]. 金属学报, 2019, 55(9): 1175-1184.
[9] 张健,王莉,王栋,谢光,卢玉章,申健,楼琅洪. 镍基单晶高温合金的研发进展[J]. 金属学报, 2019, 55(9): 1077-1094.
[10] 唐文书,肖俊峰,李永君,张炯,高斯峰,南晴. 再热恢复处理对蠕变损伤定向凝固高温合金γ′相的影响[J]. 金属学报, 2019, 55(5): 601-610.
[11] 方辉,薛桦,汤倩玉,张庆宇,潘诗琰,朱鸣芳. 定向凝固糊状区枝晶粗化和二次臂迁移的实验和模拟[J]. 金属学报, 2019, 55(5): 664-672.
[12] 杨燕, 杨光昱, 罗时峰, 肖磊, 介万奇. Mg-14.61Gd合金的定向凝固组织及生长取向[J]. 金属学报, 2019, 55(2): 202-212.
[13] 金浩, 贾清, 刘荣华, 线全刚, 崔玉友, 徐东生, 杨锐. 籽晶制备及Ti-47Al合金PST晶体取向控制[J]. 金属学报, 2019, 55(12): 1519-1526.
[14] 刘林, 孙德建, 黄太文, 张琰斌, 李亚峰, 张军, 傅恒志. 高梯度定向凝固技术及其在高温合金制备中的应用[J]. 金属学报, 2018, 54(5): 615-626.
[15] 康慧君, 李金玲, 王同敏, 郭景杰. 定向凝固Al-Mn-Be合金初生金属间化合物相生长行为及力学性能[J]. 金属学报, 2018, 54(5): 809-823.