Please wait a minute...
金属学报  2004, Vol. 40 Issue (5): 489-493     
  论文 本期目录 | 过刊浏览 |
大晶粒单相Ni-48Al金属间化合物超塑性变形过程中的组织演化
胡静; 林栋梁
上海交通大学材料科学与工程学院教育部高温材料及高温测试开放实验室; 上海200030; 江苏工业学院材料科学与工程系; 常州 213016
Microstructural Evolution During Superplastic Deformation in Large-Grained Single Phase Ni-48Al Intermetallics
HU Jing;LIN Dongliang
Open Laboratory of Education Ministry of China for High Temperature Materials and TestsSchool of Materials Science and Engineering;;Shanghai Jiaotong University; Shanghai 200030;Department of Materials Science and Engineering; Jiangsu Polytechnic University; Changzhou 213016
引用本文:

胡静; 林栋梁 . 大晶粒单相Ni-48Al金属间化合物超塑性变形过程中的组织演化[J]. 金属学报, 2004, 40(5): 489-493 .
, . Microstructural Evolution During Superplastic Deformation in Large-Grained Single Phase Ni-48Al Intermetallics[J]. Acta Metall Sin, 2004, 40(5): 489-493 .

全文: PDF(6945 KB)  
摘要: 原始平均晶粒尺寸约为200 m的单相Ni-48Al金属间化合物在温度为1025¾1100 ℃、 应变速率为1.25×10-4¾ 2.00×10-3 s-1范围内呈现超塑性. 在1100 ℃、应变速率为1.125×10-3 s-1时, 最大延伸率可达188.2%. 金相分析表明, 超塑性变形过程中晶粒明显细化;电子背散射衍射分析(EBSD)和透射电子显微术(TEM)观察表明, 超塑变形过程中形成了大量亚晶界网络, 且随变形量增大, 亚晶界及小角晶界比例不断增加. 亚晶界由位错墙和位错网络构成, 不稳定的亚晶界在超塑性变形过程中不断吸收晶内滑移和攀移位错, 亚晶界位错密度不断增加, 取向差不断增大. 伴随亚晶界的滑移和迁移及亚晶的转动, 部分亚晶界转变为小角度晶界, 并进而转变为大角度晶界, 即在超塑性变形过程中发生了连续动态回复与再结晶(CDRR).
关键词 Ni-48Al 金属间化合物 大晶粒    
Abstract:Superplastic deformation has been found in large-grained Ni-48Al intermetallics with grain size of 200 μm. Metallographic examination shows that the average grain size of the tested material decreases during superplastic deformation and much finer grains could be obtained after superplastic deformation. TEM and EBSD show that there are great numbers of subgrain boundaries and the proportion of subgrain and low angle boundaries increases with the increase of strain. During superplastic deformation an unstable subgrain network forms, which absorbs gliding and climbing dislocations and transforms into low and high angle grain boundaries accommodated by subgrain boundary sliding, migration and rotation. The observed superplastic phenomenon was explained by continuously dynamic recovery and recrystallization.
Key wordsNi-48Al    intermetallics    large-grained
收稿日期: 2003-04-16     
ZTFLH:  TG146  
[1] Lin D L, Shah A D, Li D Q. Scr Metall Mater, 1994; 31: 1455
[2] Li D Q, Shah A D, Liu Y, Lin D L. Scr Metall Mater, 1995; 33:681
[3] Lin D L, Shan A D, Chen M W. Intermetallics, 1996; 4: 489
[4] Lin D L, Li D Q, Liu Y. Intermetallics, 1998; 6:243
[5] Lin D L, Liu Y. Mater Sci Eng, 1999; A268:83
[6] Lin D L, Liu Y. Mater Sci Eng, 2002; A329:863
[7] Gu Y F, Lin D L, Shan A D, Chen J G, Hu F, Cao H Q. Acta Metall Sin, 1998; 34:351(谷月峰,林栋梁,单爱党,陈家光,胡凡,曹涵清.金属学报,1998;34:351)
[8] Sun F, Lin D L. Scr Mater, 2001; 44:665
[9] Du X H, Guo J T, Zhou B D. Scr Mater, 2001; 45:69
[10] Jiang D, Lin D L. Mater Sci Lett, 2002; 21:505
[11] Jiang D, Lin D L. Mater Lett, 2002; 57:747
[12] Kim W-Y, Hanada S, Sakai T. Mater Sci Eng, 1998; A248:78
[13] Kogachi M, Hataguchi T. Mater Sci Eng, 2001; A312:189
[14] Liu Z Y, Lin D L, Chen D. Trans Nonferrous Met Soc Chin, 1997; 7:128
[1] 丁宗业, 胡侨丹, 卢温泉, 李建国. 基于同步辐射X射线成像液/固复层界面氢气泡的形核、生长演变与运动行为的原位研究[J]. 金属学报, 2022, 58(4): 567-580.
[2] 周丽君, 位松, 郭敬东, 孙方远, 王新伟, 唐大伟. 基于飞秒激光时域热反射法的微尺度Cu-Sn金属间化合物热导率研究[J]. 金属学报, 2022, 58(12): 1645-1654.
[3] 宫声凯, 尚勇, 张继, 郭喜平, 林均品, 赵希宏. 我国典型金属间化合物基高温结构材料的研究进展与应用[J]. 金属学报, 2019, 55(9): 1067-1076.
[4] 吉华,邓运来,徐红勇,郭伟强,邓建峰,范世通. 焊接线能量对5182-O/HC260YD+Z异种材料CMT搭接接头组织与性能的影响[J]. 金属学报, 2019, 55(3): 376-388.
[5] 陈丽群, 邱正琛, 于涛. Ru对NiAl[100](010)刃型位错电子结构的影响[J]. 金属学报, 2019, 55(2): 223-228.
[6] 曹丽华, 陈胤伯, 史起源, 远杰, 刘志权. 合金元素对中温Sn-Ag-Cu焊料互连组织及剪切强度的影响[J]. 金属学报, 2019, 55(12): 1606-1614.
[7] 何贤美, 童六牛, 高成, 王毅超. Nd含量对磁控溅射Si(111)/Cr/Nd-Co/Cr薄膜结构与磁性的影响[J]. 金属学报, 2019, 55(10): 1349-1358.
[8] 张敏, 慕二龙, 王晓伟, 韩挺, 罗海龙. TA1/Cu/X65复合板焊接接头微观组织及力学性能[J]. 金属学报, 2018, 54(7): 1068-1076.
[9] 康慧君, 李金玲, 王同敏, 郭景杰. 定向凝固Al-Mn-Be合金初生金属间化合物相生长行为及力学性能[J]. 金属学报, 2018, 54(5): 809-823.
[10] 耿林, 吴昊, 崔喜平, 范国华. 基于箔材反应退火合成的TiAl基复合材料板材研究进展[J]. 金属学报, 2018, 54(11): 1625-1636.
[11] 于宣, 张志豪, 谢建新. 不同Ce含量Fe-6.5%Si合金的组织、有序结构和中温拉伸塑性[J]. 金属学报, 2017, 53(8): 927-936.
[12] 赵宁,邓建峰,钟毅,殷录桥. 热迁移下Ni/Sn-xCu/Ni微焊点钎焊界面金属间化合物的演变[J]. 金属学报, 2017, 53(7): 861-868.
[13] 张志杰,黄明亮. Cu/Sn-52In/Cu微焊点液-固电迁移行为研究[J]. 金属学报, 2017, 53(5): 592-600.
[14] 王大伟,修世超. 焊接温度对碳钢/奥氏体不锈钢扩散焊接头界面组织及性能的影响[J]. 金属学报, 2017, 53(5): 567-574.
[15] 周丽,崔超,贾清,马英石. γ-TiAl金属间化合物铣削加工实验与有限元模拟[J]. 金属学报, 2017, 53(4): 505-512.