Please wait a minute...
金属学报  2007, Vol. 43 Issue (4): 417-421     
  论文 本期目录 | 过刊浏览 |
定向凝固铁磁形状记忆合金Co-Ni-Ga的择优取向及其组织演化
谢华;刘 剑;霍颜秋;李建国
上海交通大学
The preferred orientation and microstructure changes in directionally solidified Co-Ni-Ga ferromagnetic shape memory alloys
Hua Xie;;
上海交通大学
引用本文:

谢华; 刘剑; 霍颜秋; 李建国 . 定向凝固铁磁形状记忆合金Co-Ni-Ga的择优取向及其组织演化[J]. 金属学报, 2007, 43(4): 417-421 .
, , , . The preferred orientation and microstructure changes in directionally solidified Co-Ni-Ga ferromagnetic shape memory alloys[J]. Acta Metall Sin, 2007, 43(4): 417-421 .

全文: PDF(838 KB)  
摘要: 采用液态金属冷却定向凝固方法制备出Co-Ni-Ga取向晶体, 并研究了不同晶体生长速度下, 晶体的轴向择优取向及其定向凝固组织的变化. 结果表明: 在温度梯度为250 K/cm、晶体生长速度为0.9 mm/min时, 柱晶具有完全的<110>取向, 存在单变体马氏体并有麦穗状'相析出;当生长速度提高至9 mm/min时, 合金试样为<111>+<001>+<110>混合取向, 凝固组织转变为单一的马氏体板条. EDS表明, 定向晶体沿稳定生长区轴向成分比较均匀, 无明显宏观偏析存在. 采用此方法能够获得比较长的稳定的马氏体单变体区, 为制备铁磁形状记忆合金取向多晶材料提供了新思路.
关键词 定向凝固Co-Ni-Ga合金择优取向    
Abstract:The directionally solidified Co-Ni-Ga ferromagnetic shape memory alloys were prepared by liquid metal cooling method. The preferred orientation and microstructure evolution of crystals under different growth velocity were investigated. The results indicate that keeping the temperature gradient GL=250K/cm, when the growth velocity was 0.9mm/min, a preferred orientation <110> was obtained and the worm-like second phase γ′ precipitated in the martensite matrix which was found to be coarsening along the solidification direction; While the growth velocity was increased to 9mm/min, a <110>+ <001>+<211> mixed orientation was obtained, and the single martensite phase was observed in this case. No obvious macro-segregation was detected based on the results of energy dispersive spectrometer. The paper proposes a new method to fabricate the ferromagnetic shape memory polycrystals with preferred orientation.
Key wordsdirectional solidification    Co-Ni-Ga alloy    preferred orientation    microstructure
收稿日期: 2006-07-21     
ZTFLH:  TG111.4  
[1]Ullakko K,Huang J K,Kantner C,O'Handly R C,Koko- rin V V.Appl Phys Lett,1996;69:1966
[2]O'Handley R C.J Appl Phys,1998;83:3263
[3]Chernenko V A.Scr Mater,1999;40:523
[4]Murray S J,Marioni M,Allen S M,O'Handly R C,Lo- grasso T A.Appl Phys Lett,2000;77:886
[5]Oikawa K,Wulff L,Lijima T,Gejima F,Ohmori T,Fujita A,Fukamichi K.Appl Phys Lett,2001;79:3290
[6]Oikawa K,Ota T,Gejima F,Ohmori T,Kainuma R, Ishida K.Mater Trans,2001;42:2472
[7]Wuttig M,Li J,Craciunescu C.Scr Mater,2001;44:2393
[8]Craciunescu C,Kishi Y,Lograsso T A,Wuttig M.Scr Mater,2002;47:285
[9]Sato M,Okazaki T,Furuya Y,Wuttig M.Mater Trans, 2003;44:372
[10]Fujita A,Fukamichi K,Gejima F,Kainuma R,Ishida K. Appl Phys Lett,2000;77:3054
[11]Heczko O,Sozinov A,Ullakko K.IEEE Trans Magn,2000; 36:3266
[12]Liang T,Jiang C B,Xu H B,Liu Z H,Zhang M,Cui Y T,Wu G H.J Magn Magn Mater,2004;268:29
[13]Liu J,Zheng H X,Huang Y L,Xia M X,Li J G.Scr Mater,2005;53:29
[14]Yasuda H Y,Komoto N K,Ueda M,Umakoshi Y.Sci Technol Adv Mater,2002;3:165
[15]Ji C C,Li J G,Ma W Z,Zhou Y H.J Alloy Compd,2002; 333:291
[16]Hoyt J J,Sadign B,Asta M,Floiles S M.Acta Mater, 1999;47:3181
[17]Pank D R,NathaI M V,Koss D A.J Mater Res,1990;5: 942
[18]Jiang C B,Liu J H,Zhang T,Xu H B.Acta Metall Sin, 2004;40:975 (蒋成保,刘敬华,张涛,徐惠彬.金属学报,2004;40:975)
[19]Liu J,Zheng H X,Xia M X,Huang Y L,Li J G.Scr Mater,2005;52:935
[20]Zheng H X,Ma W Z,Lu Y Y,Xia M X,Li J G.J Mater Sci,2004;39:2557
[21]Liu J,Xia M X,Huang Y L,Zheng H X,Li J G.J Alloy Compd,2006;417:96
[1] 张健, 王莉, 谢光, 王栋, 申健, 卢玉章, 黄亚奇, 李亚微. 镍基单晶高温合金的研发进展[J]. 金属学报, 2023, 59(9): 1109-1124.
[2] 马德新, 赵运兴, 徐维台, 王富. 重力对高温合金定向凝固组织的影响[J]. 金属学报, 2023, 59(9): 1279-1290.
[3] 苏震奇, 张丛江, 袁笑坦, 胡兴金, 芦可可, 任维丽, 丁彪, 郑天祥, 沈喆, 钟云波, 王晖, 王秋良. 纵向静磁场下单晶高温合金定向凝固籽晶回熔界面杂晶的形成与演化[J]. 金属学报, 2023, 59(12): 1568-1580.
[4] 李彦强, 赵九洲, 江鸿翔, 何杰. Pb-Al合金定向凝固组织形成过程[J]. 金属学报, 2022, 58(8): 1072-1082.
[5] 陈瑞润, 陈德志, 王琪, 王墅, 周哲丞, 丁宏升, 傅恒志. Nb-Si基超高温合金及其定向凝固工艺的研究进展[J]. 金属学报, 2021, 57(9): 1141-1154.
[6] 张小丽, 冯丽, 杨彦红, 周亦胄, 刘贵群. 二次枝晶取向对镍基高温合金晶粒竞争生长行为的影响[J]. 金属学报, 2020, 56(7): 969-978.
[7] 许庆彦,杨聪,闫学伟,柳百成. 高温合金涡轮叶片定向凝固过程数值模拟研究进展[J]. 金属学报, 2019, 55(9): 1175-1184.
[8] 张健,王莉,王栋,谢光,卢玉章,申健,楼琅洪. 镍基单晶高温合金的研发进展[J]. 金属学报, 2019, 55(9): 1077-1094.
[9] 方辉,薛桦,汤倩玉,张庆宇,潘诗琰,朱鸣芳. 定向凝固糊状区枝晶粗化和二次臂迁移的实验和模拟[J]. 金属学报, 2019, 55(5): 664-672.
[10] 唐文书,肖俊峰,李永君,张炯,高斯峰,南晴. 再热恢复处理对蠕变损伤定向凝固高温合金γ′相的影响[J]. 金属学报, 2019, 55(5): 601-610.
[11] 杨燕, 杨光昱, 罗时峰, 肖磊, 介万奇. Mg-14.61Gd合金的定向凝固组织及生长取向[J]. 金属学报, 2019, 55(2): 202-212.
[12] 金浩, 贾清, 刘荣华, 线全刚, 崔玉友, 徐东生, 杨锐. 籽晶制备及Ti-47Al合金PST晶体取向控制[J]. 金属学报, 2019, 55(12): 1519-1526.
[13] 康慧君, 李金玲, 王同敏, 郭景杰. 定向凝固Al-Mn-Be合金初生金属间化合物相生长行为及力学性能[J]. 金属学报, 2018, 54(5): 809-823.
[14] 苏彦庆, 刘桐, 李新中, 陈瑞润, 郭景杰, 傅恒志. 籽晶法定向凝固TiAl基合金片层取向控制[J]. 金属学报, 2018, 54(5): 647-656.
[15] 侯渊, 任忠鸣, 王江, 张振强, 李霞. 纵向静磁场对定向凝固GCr15轴承钢柱状晶向等轴晶转变的影响[J]. 金属学报, 2018, 54(5): 801-808.