|
|
Tribological Property and Wear Mechanism of NbMoZrVSi x Refractory High-Entropy Alloy Strengthened by Eutectic Structure |
WANG Hanming, DU Yin( ), PEI Xuhui, WANG Haifeng( ) |
Center of Advanced Lubrication and Seal Materials, State Key Laboratory of Solidification Processing, Northwestern Polytechnical University, Xi'an 710072, China |
|
Cite this article:
WANG Hanming, DU Yin, PEI Xuhui, WANG Haifeng. Tribological Property and Wear Mechanism of NbMoZrVSi x Refractory High-Entropy Alloy Strengthened by Eutectic Structure. Acta Metall Sin, 2024, 60(7): 937-946.
|
Abstract In recent years, refractory high-entropy alloys (RHEAs) have gained widespread attention owing to their high structural stability and excellent mechanical properties at both room and elevated temperatures. However, their wear resistance at room temperature is often poor due to their fragility. In this study, the effect of adding small amounts of silicon (Si) to NbMoZrV RHEA on its tribological properties and wear mechanism at room temperature have been studied using various techniques including tribometer, SEM, and XPS. The results showed that adding a moderate amount of Si induced the homogeneous precipitation of a eutectic structure composed of Zr-Zr3Si phase at the bcc matrix grain boundary. This eutectic structure significantly improved the hardness and wear resistance of the NbMoZrVSi0.1 RHEA. Unlike the poor tribological behavior observed in NbMoZrVSi0.05 and NbMoZrVSi0.2 RHEAs, the NbMoZrVSi0.1 RHEA exhibited stable coefficient of friction and wear rate under dry sliding wear test at room temperature with varying normal loads. The Zr-Zr3Si eutectic structure effectively inhibited the initiation and propagation of cracks and brittle spalling during the sliding wear test, resulting in only slight abrasive wear of the NbMoZrVSi0.1 RHEA. Moreover, the mechanism promoted the subsequent homogeneous oxidation of the worn surface.
|
Received: 07 May 2022
|
|
Fund: National Natural Science Foundation of China(51975474);Fundamental Research Funds for the Central Universities(3102019JC001) |
Corresponding Authors:
DU Yin, Tel: 18049591909, E-mail: duyin@nwpu.edu.cn;
|
1 |
Yeh J W, Chen S K, Lin S J, et al. Nanostructured high-entropy alloys with multiple principal elements: Novel alloy design concepts and outcomes [J]. Adv. Eng. Mater., 2004, 6: 299
|
2 |
Yeh J W, Chen S K, Chin T S, et al. Formation of simple crystal structures in Cu-Co-Ni-Cr-Al-Fe-Ti-V alloys with multiprincipal metallic elements [J]. Metall. Mater. Trans., 2004, 35A: 2533
|
3 |
Huang P K, Yeh J W, Shun T T, et al. Multi-principal-element alloys with improved oxidation and wear resistance for thermal spray coating [J]. Adv. Eng. Mater., 2004, 6: 74
|
4 |
Hsu C Y, Yeh J W, Chen S K, et al. Wear resistance and high-temperature compression strength of FCC CuCoNiCrAl0.5Fe alloy with boron addition [J]. Metall. Mater. Trans., 2004, 35A: 1465
|
5 |
Senkov O N, Wilks G B, Miracle D B, et al. Refractory high-entropy alloys [J]. Intermetallics, 2010, 18: 1758
|
6 |
Han Z D, Luan H W, Liu X, et al. Microstructures and mechanical properties of Ti x NbMoTaW refractory high-entropy alloys [J]. Mater. Sci. Eng., 2018, A712: 380
|
7 |
Huang H L, Wu Y, He J Y, et al. Phase-transformation ductilization of brittle high-entropy alloys via metastability engineering [J]. Adv. Mater., 2017, 29: 1701678
|
8 |
Guo W, Dmowski W, Noh J Y, et al. Local atomic structure of a high-entropy alloy: An X-ray and neutron scattering study [J]. Metall. Mater. Trans., 2013, 44A: 1994
|
9 |
Ranganathan S. Alloyed pleasures: Multimetallic cocktails [J]. Curr. Sci., 2003, 85: 1404
|
10 |
Li Q, Chen W M, Zhong J, et al. On sluggish diffusion in fcc Al-Co-Cr-Fe-Ni high-entropy alloys: An experimental and numerical study [J]. Metals, 2017, 8: 16
|
11 |
Kottke J, Laurent-Brocq M, Fareed A, et al. Tracer diffusion in the NiCoCrFeMn system: Transition from a dilute solid solution to a high entropy alloy [J]. Scr. Mater., 2019, 159: 94
|
12 |
Mehta A, Sohn Y. Investigation of sluggish diffusion in FCC Al0.25CoCrFeNi high-entropy alloy [J]. Mater. Res. Lett., 2021, 9: 239
|
13 |
Lin C M, Juan C C, Chang C H, et al. Effect of Al addition on mechanical properties and microstructure of refractory Al x HfNbTaTiZr alloys [J]. J. Alloys Compd., 2015, 624: 100
|
14 |
Fan L, Yang T, Zhao Y L, et al. Ultrahigh strength and ductility in newly developed materials with coherent nanolamellar architectures [J]. Nat. Commun., 2020, 11: 6240
doi: 10.1038/s41467-020-20109-z
pmid: 33288762
|
15 |
Nguyen N T C, Asghari-Rad P, Sathiyamoorthi P, et al. Ultrahigh high-strain-rate superplasticity in a nanostructured high-entropy alloy [J]. Nat. Commun., 2020, 11: 2736
|
16 |
Öztürk S, Alptekin F, Önal S, et al. Effect of titanium addition on the corrosion behavior of CoCuFeNiMn high entropy alloy [J]. J. Alloys Compd., 2022, 903: 163867
|
17 |
Ji C W, Ma A B, Jiang J H. Mechanical properties and corrosion behavior of novel Al-Mg-Zn-Cu-Si lightweight high entropy alloys [J]. J. Alloys Compd., 2022, 900: 163508
|
18 |
Manea C A, Sohaciu M, Stefănoiu R, et al. New HfNbTaTiZr high-entropy alloy coatings produced by electrospark deposition with high corrosion resistance [J]. Materials, 2021, 14: 4333
|
19 |
Pei X H, Du Y, Hao X X, et al. Microstructure and tribological properties of TiZrV0.5Nb0.5Al x refractory high entropy alloys at elevated temperature [J]. Wear, 2022, 488-489: 204166
|
20 |
Miao J W, Liang H, Zhang A J, et al. Tribological behavior of an AlCoCrFeNi2.1 eutectic high entropy alloy sliding against different counterfaces [J]. Tribol. Int., 2021, 153: 106599
|
21 |
Senkov O N, Wilks G B, Scott J M, et al. Mechanical properties of Nb25Mo25Ta25W25 and V20Nb20Mo20Ta20W20 refractory high entropy alloys [J]. Intermetallics, 2011, 19: 698
|
22 |
Poulia A, Georgatis E, Lekatou A, et al. Dry-sliding wear response of MoTaWNbV high entropy alloy [J]. Adv. Eng. Mater., 2017, 19: 1600535
|
23 |
Poulia A, Georgatis E, Karantzalis A. Evaluation of the microstructural aspects, mechanical properties and dry sliding wear response of MoTaNbVTi refractory high entropy alloy [J]. Met. Mater. Int., 2019, 25: 1529
|
24 |
Mathiou C, Poulia A, Georgatis E, et al. Microstructural features and dry-sliding wear response of MoTaNbZrTi high entropy alloy [J]. Mater. Chem. Phys., 2018, 210: 126.
|
25 |
Song Q T, Xu Y K, Xu J. Dry-slidingwear behavior of (TiZrNbTa)90-Mo10 high-entropy alloy against Al2O3 [J]. Acta Metall. Sin., 2020, 56: 1507
|
|
宋芊汀, 徐映坤, 徐 坚. (TiZrNbTa)90Mo10高熵合金与Al2O3干摩擦条件下的滑动磨损行为[J]. 金属学报, 2020, 56: 1507
doi: 10.11900/0412.1961.2020.00031
|
26 |
Pole M, Sadeghilaridjani M, Shittu J, et al. High temperature wear behavior of refractory high entropy alloys based on 4-6 elemental palette [J]. J. Alloys Compd., 2020, 843: 156004
|
27 |
Du Y, Pei X H, Tang Z W, et al. Mechanical and tribological performance of CoCrNiHf x eutectic medium-entropy alloys [J]. J. Mater. Sci. Technol., 2021, 90: 194
|
28 |
Guo N N, Wang L, Luo L S, et al. Microstructure and mechanical properties of refractory high entropy (Mo0.5NbHf0.5ZrTi)BCC/M5Si3 in-situ compound [J]. J. Alloys Compd., 2016, 660: 197
|
29 |
Deng G Y, Tieu A K, Lan X D, et al. Effects of normal load and velocity on the dry sliding tribological behaviour of CoCrFeNiMo0.2 high entropy alloy [J]. Tribol. Int., 2020, 144: 106116
|
30 |
Choi H, Jang J, Zhang T F, et al. Effect of Si addition on the microstructure, mechanical properties and tribological properties of Zr-Si-N nanocomposite coatings deposited by a hybrid coating system [J]. Surf. Coat. Technol., 2014, 259: 707
|
31 |
Xin B B, Zhang A J, Han J S, et al. Improving mechanical properties and tribological performance of Al0.2Co1.5CrFeNi1.5Ti0.5 high entropy alloys via doping Si [J]. J. Alloys Compd., 2021, 869: 159122
|
No Suggested Reading articles found! |
|
|
Viewed |
|
|
|
Full text
|
|
|
|
|
Abstract
|
|
|
|
|
Cited |
|
|
|
|
|
Shared |
|
|
|
|
|
Discussed |
|
|
|
|