Please wait a minute...
金属学报  1989, Vol. 25 Issue (6): 37-42    
  论文 本期目录 | 过刊浏览 |
Cr-Mn-N不锈钢的低周疲劳
夏月波;王中光
中国科学院金属研究所;副研究员;沈阳(110015);中国科学院金属研究所
LOW CYCLE FATIGUE OF Cr-Mn-N STAINLESS STEEL
XIA Yuebo;WANG Zhongguang Institute of Metal Research; Academia Sinica; Shenyang XIA Yuebo; associate professor; Institute of Metal Research; Academia Sinica;Shenyang 110015
引用本文:

夏月波;王中光. Cr-Mn-N不锈钢的低周疲劳[J]. 金属学报, 1989, 25(6): 37-42.
, . LOW CYCLE FATIGUE OF Cr-Mn-N STAINLESS STEEL[J]. Acta Metall Sin, 1989, 25(6): 37-42.

全文: PDF(932 KB)  
摘要: 本文研究了Cr-Mn-N不锈钢的对称拉压低周疲劳行为。结果表明,在相同的总应变幅下,1050℃固溶处理比1250℃固溶处理的试样的疲劳寿命几乎高一倍。在所使用的应变幅(±0.4—±1.2%)范围内,循环到饱和后都观察到软化现象,而在低应变幅下较早到达饱和阶段。每周的平均能量损耗随应变幅的增加而增加,而试样全寿命的总能量损耗则随应变幅的增加而降低。疲劳试样断口的扫描电子显微镜观察表明,低温固溶处理的试样断口为穿晶和沿晶的混合型断裂,以穿晶为主,并有清晰的疲劳条纹。高温固溶处理的试样断口则以沿晶断裂为主。
关键词 低周疲劳疲劳寿命硬化饱和循环软化能量损耗    
Abstract:An investigation was conducted to examine the symmetric lowcycle push-pull fatigue behaviour of the Cr-Mn-N dual-phase stainless steel whichwas separated into two specimen groups A and B by solution treated at 1050 and1250℃ respectively. The fatigue life of A is almost twice as long as B under sametotal amplitude of strain. Within the tested amplitude range of strain, ±0.4-±1.2%, the cyclic softening is observed both of them after the cycle saturated, whilethe saturation stage is earlier reached under lower amplitude of strain. The aver-age energy loss of each cycle increases and the sum of energy loss of total life ofeach specimen decreases with the increase of strain amplitude. Observation on thefatigue fracture surface under SEM shows that the specimen A is mixed type and thetransgranular mode predominantly with clear fatigue striation, and the specimen Bis mainly the intergranular mode.
Key wordslow cycle fatigue    fatigue life    hardening saturation    cyclic softening    energy loss
收稿日期: 1989-06-18     
基金资助:中国科学院重大科研项目
1 中国科学院金属研究所.Cr-Mn-N无镍不锈钢综合简介,金属研究所内部资料,1972
2 柴田浩司,名村夏树,岸本康夫,藤田利夫.铁钢,1983;69(16) :2076
3 Xia Y B (夏月波), Wang Z G (王中光). Phys Status Solidi, (a), 1987; 103: 389
4 Raske D T, Morrow J D. ASTM STP 465, 1969: 1
[1] 江河, 佴启亮, 徐超, 赵晓, 姚志浩, 董建新. 镍基高温合金疲劳裂纹急速扩展敏感温度及成因[J]. 金属学报, 2023, 59(9): 1190-1200.
[2] 宋文硕, 宋竹满, 罗雪梅, 张广平, 张滨. 粗糙表面高强铝合金导线疲劳寿命预测[J]. 金属学报, 2022, 58(8): 1035-1043.
[3] 周红伟, 高建兵, 沈加明, 赵伟, 白凤梅, 何宜柱. 高温低周疲劳下C-HRA-5奥氏体耐热钢中孪晶界演变[J]. 金属学报, 2022, 58(8): 1013-1023.
[4] 潘庆松, 崔方, 陶乃镕, 卢磊. 纳米孪晶强化304奥氏体不锈钢的应变控制疲劳行为[J]. 金属学报, 2022, 58(1): 45-53.
[5] 周红伟, 白凤梅, 杨磊, 陈艳, 方俊飞, 张立强, 衣海龙, 何宜柱. 1100 MPa级高强钢的低周疲劳行为[J]. 金属学报, 2020, 56(7): 937-948.
[6] 孙飞龙, 耿克, 俞峰, 罗海文. 超洁净轴承钢中夹杂物与滚动接触疲劳寿命的关系[J]. 金属学报, 2020, 56(5): 693-703.
[7] 张哲峰,邵琛玮,王斌,杨浩坤,董福元,刘睿,张振军,张鹏. 孪生诱发塑性钢拉伸与疲劳性能及变形机制[J]. 金属学报, 2020, 56(4): 476-486.
[8] 吴正凯, 吴圣川, 张杰, 宋哲, 胡雅楠, 康国政, 张海鸥. 基于同步辐射X射线成像的选区激光熔化Ti-6Al-4V合金缺陷致疲劳行为[J]. 金属学报, 2019, 55(7): 811-820.
[9] 张啸尘, 孟维迎, 邹德芳, 周鹏, 石怀涛. 预循环应力对高速列车关键结构用铝合金材料疲劳裂纹扩展行为的影响[J]. 金属学报, 2019, 55(10): 1243-1250.
[10] 宋哲, 吴圣川, 胡雅楠, 康国政, 付亚楠, 肖体乔. 冶金型气孔对熔化焊接7020铝合金疲劳行为的影响[J]. 金属学报, 2018, 54(8): 1131-1140.
[11] 张哲峰, 刘睿, 张振军, 田艳中, 张鹏. 金属材料疲劳性能预测统一模型探索[J]. 金属学报, 2018, 54(11): 1693-1704.
[12] 安金岚,王磊,刘杨,胥国华,赵光普. 长期时效对GH4169合金组织演化及低周疲劳行为的影响*[J]. 金属学报, 2015, 51(7): 835-843.
[13] 车欣, 梁兴奎, 陈丽丽, 陈立佳, 李锋. Al-9.0%Si-4.0%Cu-0.4%Mg(-0.3%Sc)合金的显微组织及其低周疲劳行为*[J]. 金属学报, 2014, 50(9): 1046-1054.
[14] 张思倩, 吴伟, 陈丽丽, 车欣, 陈立佳. 热处理对挤压变形Mg-7%Zn-0.6%Zr-0.5%Y合金低周疲劳行为的影响*[J]. 金属学报, 2014, 50(6): 700-706.
[15] 郭鹏程, 钱立和, 孟江英, 张福成. 高锰奥氏体TWIP钢的单向拉伸与拉压循环变形行为*[J]. 金属学报, 2014, 50(4): 415-422.