STUDY ON THE HOT DEFORMATION BEHAVIOR AND HOT WORKABILITY OF Mg-Y-Nd-Zr ALLOY

Acta Metall Sin

2006, Vol. 42

Issue (10): 1096-1100 DOI:

Research Articles

Current Issue | Archive | Adv Search

STUDY ON THE HOT DEFORMATION BEHAVIOR AND HOT WORKABILITY OF Mg-Y-Nd-Zr ALLOY

Wei-Neng TANG;;

中国科学院金属研究所环境腐蚀中心

Cite this article:

Wei-Neng TANG. STUDY ON THE HOT DEFORMATION BEHAVIOR AND HOT WORKABILITY OF Mg-Y-Nd-Zr ALLOY. Acta Metall Sin, 2006, 42(10): 1096-1100 .

Download:

PDF(264KB)
Export: BibTeX | EndNote (RIS)

Abstract The deformation behaviour of Mg-Y-Nd-Zr alloy at temperatures of 300-500℃ and strain rates of 0.001-1s-1 has been studied by compressive tests. Processing map of this alloy was established on the basis of Dynamic Material Model; it is suggested that, with microstructural observation, the processing map of this alloy could be characterized as the following four domains: First, dynamic recrystallization (DRX) domain at 450-500℃ and about 0.01s-1. Second, boundary cracking domain at temperatures higher than 450℃ and strain rates of about 0.005s-1. Third, flow instability domain probably due to mechanical twinning at temperature lower than 350℃ and strain rate of about 0.01s-1. Last, shearing fracture at about 450℃ and strain rates higher than 0.5s-1.

Key words: Mg-Y-Nd alloy hot deformation processing map hot workability mechanical properties

Received: 15 May 2006

ZTFLH:

TG113.26

	Service

	E-mail this article
	Add to citation manager
	E-mail Alert
	RSS
	（）
	Articles by authors
	Wei-Neng TANG

URL:

https://www.ams.org.cn/EN/ OR https://www.ams.org.cn/EN/Y2006/V42/I10/1096

[1]Pekguleryuz M O,Kaya A A.Adv Eng Mater,2003;5:866
[2]Smola B,Stulikova I,Von Buch F,Mordike B L.Mater Sci Eng,2002;A324:113
[3]Wang J G,Hsiung L M,Nieh T G,Mabuchi M.Mater SciEng,2001;A315:81
[4]Mohri T,Mabuchi M,Saito N,Nakamura M.Mater Sci Eng,1998;A257:287
[51Watanabe H,Mukai T,Ishikawa K,Mohri T,Mabuchi M,Higashi K.Mater Trans,2001;42:157
[6]Sha G Y,Han E H,Yu T,Xu Y B,Liu L,Gao G Z.Acta Metall Sin,2003;39:1025(沙桂英，韩恩厚，于涛，徐永波，刘路，高国忠．金属学报，2003；39：1025)
[7]Mordike B L.Mater Sci Eng,2002;A324:103
[8]Polmear I J.Mater Trans JIM,1996;37(1):12
[9]Sivakesavam O,Prasad Y V R K.Mater Sci Eng,2002;A323:270
[10]Sivakesavam O,Prasad Y V R K.Mater Sci Eng,2003;A362:118
[11]Sivakesavam O,Rao I S,Prasad Y V R K.Mater Sci Technol,1993;9:805
[12]Nie J F,Muddle B C.Acta Mater,2000;48:1691
[13]Prasad Y V R K,Seshacharyulu T.Int Mater Rev,1998;43:243
[14]Narauana M S V S,Nageswara R B,Kashyap B P.Int Mater Rev,2000;45:15
[15]Raj R.Metall Trans,1981;12A:1089

[1]	LI Fulin, FU Rui, BAI Yunrui, MENG Lingchao, TAN Haibing, ZHONG Yan, TIAN Wei, DU Jinhui, TIAN Zhiling. Effects of Initial Grain Size and Strengthening Phase on Thermal Deformation and Recrystallization Behavior of GH4096 Superalloy[J]. 金属学报, 2023, 59(7): 855-870.
[2]	SUN Yi, ZHENG Qinyuan, HU Baojia, WANG Ping, ZHENG Chengwu, LI Dianzhong. Mechanism of Dynamic Strain-Induced Ferrite Transformation in a 3Mn-0.2C Medium Mn Steel[J]. 金属学报, 2022, 58(5): 649-659.
[3]	YAN Mengqi, CHEN Liquan, YANG Ping, HUANG Lijun, TONG Jianbo, LI Huanfeng, GUO Pengda. Effect of Hot Deformation Parameters on the Evolution of Microstructure and Texture of β Phase in TC18 Titanium Alloy[J]. 金属学报, 2021, 57(7): 880-890.
[4]	NI Ke, YANG Yinhui, CAO Jianchun, WANG Liuhang, LIU Zehui, QIAN Hao. Softening Behavior of 18.7Cr-1.0Ni-5.8Mn-0.2N Low Nickel-Type Duplex Stainless Steel During Hot Compression Deformation Under Large Strain[J]. 金属学报, 2021, 57(2): 224-236.
[5]	LIU Chao, YAO Zhihao, JIANG He, DONG Jianxin. The Feasibility and Process Control of Uniform Equiaxed Grains by Hot Deformation in GH4720Li Alloy with Millimeter-Level Coarse Grains[J]. 金属学报, 2021, 57(10): 1309-1319.
[6]	LI Tianrui, LIU Guohuai, YU Shaoxia, WANG Wenjuan, ZHANG Fengyi, PENG Quanyi, WANG Zhaodong. Microstructure Evolution and Deformation Mechanisms by Direct Hot-Pack Rolling for As-Cast Ti-46Al-8Nb Alloys[J]. 金属学报, 2020, 56(8): 1091-1102.
[7]	ZHOU Li, LI Ming, WANG Quanzhao, CUI Chao, XIAO Bolv, MA Zongyi. Study of the Hot Deformation and Processing Map of 31%B₄Cp/6061Al Composites[J]. 金属学报, 2020, 56(8): 1155-1164.
[8]	CHEN Wenxiong, HU Baojia, JIA Chunni, ZHENG Chengwu, LI Dianzhong. Post-Dynamic Softening of Austenite in a Ni-30%Fe Model Alloy After Hot Deformation[J]. 金属学报, 2020, 56(6): 874-884.
[9]	WANG Tao,WAN Zhipeng,LI Zhao,LI Peihuan,LI Xinxu,WEI Kang,ZHANG Yong. Effect of Heat Treatment Parameters on Microstructure and Hot Workability of As-Cast Fine Grain Ingot of GH4720Li Alloy[J]. 金属学报, 2020, 56(2): 182-192.
[10]	ZHANG Yong, LI Xinxu, WEI Kang, WAN Zhipeng, JIA Chonglin, WANG Tao, LI Zhao, SUN Yu, LIANG Hongyan. Hot Deformation Characteristics of Novel Wrought Superalloy GH4975 Extruded Rod Used for 850 ℃ Turbine Disc[J]. 金属学报, 2020, 56(10): 1401-1410.
[11]	MA Kai, ZHANG Xingxing, WANG Dong, WANG Quanzhao, LIU Zhenyu, XIAO Bolv, MA Zongyi. Optimization and Simulation of Deformation Parameters of SiC/2009Al Composites[J]. 金属学报, 2019, 55(10): 1329-1337.
[12]	Bolü XIAO, Zhiye HUANG, Kai MA, Xingxing ZHANG, Zongyi MA. Research on Hot Deformation Behaviors of Discontinuously Reinforced Aluminum Composites[J]. 金属学报, 2019, 55(1): 59-72.
[13]	Xiting ZHONG, Lei WANG, Feng LIU. Study on Formation Mechanism of Necklace Structure in Discontinuous Dynamic Recrystallization of Incoloy 028[J]. 金属学报, 2018, 54(7): 969-980.
[14]	Yusen SU, Yinhui YANG, Jianchun CAO, Yuliang BAI. Research on Hot Working Behavior of Low-NickelDuplex Stainless Steel 2101[J]. 金属学报, 2018, 54(4): 485-493.
[15]	Ming ZHANG, Guoquan LIU, Benfu HU. Effect of Microstructure Instability on Hot Plasticity During Thermomechanical Processing in PM Nickel-Based Superalloy[J]. 金属学报, 2017, 53(11): 1469-1477.

No Suggested Reading articles found!

Viewed

Full text

Abstract

Cited

Shared

Discussed