低碳Nb微合金钢中Nb溶质拖曳和析出相NbC钉扎对再结晶晶粒长大的影响

doi:10.3724/SP.J.1037.2010.00110

金属学报

2010, Vol. 46

Issue (7): 832-837 DOI: 10.3724/SP.J.1037.2010.00110

论文

本期目录 | 过刊浏览

低碳Nb微合金钢中Nb溶质拖曳和析出相NbC钉扎对再结晶晶粒长大的影响

付立铭, 单爱党, 王巍

1) 上海交通大学材料科学与工程学院, 上海 200240
2) 宝山钢铁股份有限公司研究院, 上海 201900

EFFECT OF Nb SOLUTE DRAG AND NbC PRECIPITATE PINNING ON THE RECRYSTALLIZATION GRAIN GROWTH IN LOW CARBON Nb-MICROACLOYED STEEL

FU Liming, SHAN Aidang, WANG Wei

1) School of Material Science and Engineering, Shanghai Jiaotong University, Shanghai 200240
2) Research Institute, Baoshan Iron

$\&$ Steel Co., Ltd., Shanghai 201900

引用本文:

付立铭单爱党王巍. 低碳Nb微合金钢中Nb溶质拖曳和析出相NbC钉扎对再结晶晶粒长大的影响[J]. 金属学报, 2010, 46(7): 832-837.
, , . EFFECT OF Nb SOLUTE DRAG AND NbC PRECIPITATE PINNING ON THE RECRYSTALLIZATION GRAIN GROWTH IN LOW CARBON Nb-MICROACLOYED STEEL[J]. Acta Metall Sin, 2010, 46(7): 832-837.

全文: PDF(896 KB)

摘要:

通过理论计算并结合实验研究了低碳Nb微合金钢中NbC析出相与Nb固溶原子共同作用对再结晶后奥氏体晶粒长大的影响. 结果表明, Nb的溶质原子拖曳与NbC析出相钉扎共同作用阻碍晶粒长大晶界的迁移, 高温时NbC析出相的钉扎起主要作用, Nb的溶质拖曳效应并不明显, 而相对低温时Nb拖曳对晶粒长大产生明显地抑制作用, 理论计算与实验结果吻合良好; 溶质原子拖曳和析出相的钉扎对抑制晶粒长大的效力可以用p因子来表征, 当p=0时, 以NbC析出的Nb与固溶Nb的量之比达到最优, 抑制晶粒长大效果最好, 当p>0时, 析出相的钉扎能更有效地阻碍晶粒长大, 而p<0时, 溶质原子的拖曳对抑制晶粒的长大更有效; 在常规热轧温度区间或者奥氏体化温度区间内, 只有尺寸不大于10 nm的细小的NbC析出相对再结晶后的晶粒长大才能起到较好抑制作用.

关键词 ：晶粒长大, 析出相钉扎, 溶质拖曳, 低碳Nb微合金钢

Abstract：

A kinetic equation for austenite grain growth has been derived concerning the mutual effect of NbC and Nb solute in low carbon Nb-microalloyed steels. It is shown that both solute drag of Nb in solid solution and pinning of NbC particles inhibit the grain boundary migration during grain growth after recrystallization in low carbon Nb-microalloyed steels. At high temperatures the NbC pinning plays a dominate role for retarding the austenite grain growth with less Nb solute drag effect. An obvious Nb solute drag restraint was, however, observed at relatively low temperatures. Also, the theoretical calculations are in good agreement with experimental results. The effectiveness of drag effect of soluble atoms and pinning effect of precipitates can be characterized by a p factor. The pinning of precipitates and solute drag of soluble atoms are more effective for suppressing grain growth as p>0 and p<0, respectively. And the ratio of Nb in solute and Nb in precipitate as p=0 reaches the priority and most effectively retards the grain growth. In the traditional hot rolling or< austenitizing temperature range, a strong suppression for grain growth after recrystallization could be obtained due to those fine NbC particles smaller than 10 nm in Nb-microalloyed steels.

Key words： grain growth precipitates pinning solute drag low carbon Nb-microalloyed steel

收稿日期: 2010-03-04

作者简介: 付立铭, 男, 1977年生, 博士

	服务

	把本文推荐给朋友
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	付立铭
	单爱党
	王巍
44.8K

链接本文:

https://www.ams.org.cn/CN/10.3724/SP.J.1037.2010.00110 或 https://www.ams.org.cn/CN/Y2010/V46/I7/832

[1] Zener C. Trans AIME, 1948; 175: 47
[2] Smith C S. Trans AIME, 1948; 175: 15
[3] Cahn J W. Acta Metall, 1962; 10: 789
[4] Wang H R, Wang W. Mater Sci Technol, 2007; 23: 1305
[5] Zurob H S. PhD Thesis, McMaster University, Hamilton, 2003
[6] Sinclair C W, Huchinson C R, Brechet Y. Metall Trans, 2007; 38A: 821
[7] Qiao G Y, Xiao F R, Zhang X B, Cao Y B, Liao B. Trans Nonferrous Met Soc China, 2009; 19: 1395
[8] Wang X L, Wei Y H, Wang W, Hou L F. Acta Metall Sin (Engl Lett), 2008; 21: 8
[9] Zurob H S, Brechet Y, Purdy G. Acta Mater, 2001; 49: 4183
[10] Zhang Z H, Liu Y N, Liang X K, She Y. Mater Sci Eng, 2008; A474: 254
[11] Zaky Farahat A I. J Mater Proc Technol, 2008; 204: 365
[12] Bai D Q, Yue S, Sun W P, Jonas J J. Metall Mater Trans, 1993; 24A: 2151
[13] Maruyama N, Uemori R, Sugiyama M. Mater Sci Eng, 1998; A250: 2
[14] Beck P A, Kremer J C, Demer L J. Trans AIME, 1948; 175: 372
[15] Hillert M. Acta Metall, 1965; 13: 227
[16] Turnbull D. Trans AIME, 1951; 191: 661
[17] Mazzi N, Rouag N. Model Simul Mater Sci Eng, 2001; 9: 423
[18] Hansen S S, Vandersande J B, Cohen M. Metall Trans, 1980; 11A: 387
[19] Humphreys F J, Hatherly M. Recrystallization and Related Annealing Phenomena. Oxford: Pergamon Press, 1996: 11
[20] Ashby M F, Harper J, Lewis J. Trans Metall Soc AIME, 1969; 245: 413
[21] Doherty R D. Met Sci, 1982; 16: 1
[22] Gladman T. The Physical Metallurgy of Microallyed Steel. London: Institute of Metals, 1997: 1
[23] Zhang P J, Fu L M, Wang W. Iron Steel Suppl, 2005; 40: 666
[24] Maruyama N, Smith G DW. Mater Sci Forum, 2004; 467– 470: 949
[25] Mclean D. Grain Boundaries in Metals. Oxford: Clarendon, 1957: 116
[26] Wang W, Wang H R. Mater Lett, 2007; 61: 2227
[27] Dutta B, Palmiere E J, Sellars C M. Acta Mater, 2001; 49: 785
[28] Frost H J, Ashby M F. Deformation–Mechanism Maps. Oxford: Pergamon Press, 1982: 21
[29] Enomoto M, Aaronson H I. Metall Trans, 1986; 17A: 1381
[30] Gamsjager E, Svoboda J, Fischer F D. Comput Mater Sci, 2005; 32: 360
[31] James D W, Leak G M. Philos Mag, 1965; 12: 491
[32] Geise J, Herzig C. Z Metallkd, 1985; 76: 622
[33] Jones A R, Ralph B. Acta Metall, 1975; 23: 355
[34] Jonas J J, AkbenM G. Mater Forum, 1981; 4: 92
[35] Dutta B, Sellars C M. Mater Sci Technol, 1987; 3: 97

[1]	韩汝洋, 杨庚蔚, 孙新军, 赵刚, 梁小凯, 朱晓翔. 钒微合金化中锰马氏体耐磨钢奥氏体晶粒长大行为[J]. 金属学报, 2022, 58(12): 1589-1599.
[2]	刘峰, 黄林科, 陈豫增. 纳米晶金属材料中相变与晶粒长大的共生现象[J]. 金属学报, 2018, 54(11): 1525-1536.
[3]	惠亚军,潘辉,李文远,刘锟,陈斌,崔阳. 1000 MPa级Nb-Ti微合金化超高强度钢加热制度研究[J]. 金属学报, 2017, 53(2): 129-139.
[4]	周德强, 刘雄军, 吴渊, 王辉, 吕昭平. 新型奥氏体耐热不锈钢再结晶行为及其对力学性能的影响[J]. 金属学报, 2014, 50(10): 1217-1223.
[5]	聂文金尚成嘉吴圣杰施培建程俊杰张晓兵. Nb对奥氏体热变形后等温回复的影响[J]. 金属学报, 2012, 48(7): 775-781.
[6]	张转转武传松高进强 . TCS不锈钢复合热源焊接热影响区晶粒长大的预测[J]. 金属学报, 2012, 48(2): 199-204.
[7]	周广钊王永欣陈铮. 相场法模拟不同形状的硬质颗粒对两相晶粒长大的影响[J]. 金属学报, 2012, 48(2): 227-234.
[8]	韩利战陈睿恺顾剑锋潘健生. X12CrMoWVNbN10-1-1铁素体耐热钢奥氏体晶粒长大行为的研究[J]. 金属学报, 2009, 45(12): 1446-1450.
[9]	岳景朝王浩刘国权栾军华. 一个基于平均N面体模型的晶粒长大速率方程[J]. 金属学报, 2009, 45(12): 1421-1424.
[10]	高英俊张海林金星黄创高罗志荣. 相场方法研究硬质颗粒钉扎的两相晶粒长大过程[J]. 金属学报, 2009, 45(10): 1190-1198.
[11]	陈礼清隋凤利刘相华. Inconel 718合金方坯粗轧加热过程晶粒长大模型[J]. 金属学报, 2009, 45(10): 1242-1248.
[12]	王浩; 刘国权 . 基于MacPherson-Srolovitz 拓扑依赖速率方程的三维晶粒尺寸分布研究[J]. 金属学报, 2008, 44(7): 769-774 .
[13]	韩清超; 宋晓艳; 李凌梅; 刘雪梅 . 基于热力学函数的纳米晶粒长大Cellular Automaton仿真研究[J]. 金属学报, 2008, 44(4): 495-500 .
[14]	王浩; 刘国权 . 凸形多面体个体晶粒的三维von Neumann准确方程[J]. 金属学报, 2008, 44(11): 1332-1334 .
[15]	王浩; 刘国权; 秦湘阁 . 三维晶粒长大速率方程的大尺度Potts模型Monte Carlo仿真验证[J]. 金属学报, 2008, 44(1): 13-18 .

Viewed

Full text

Abstract

Cited

Shared

Discussed