Please wait a minute...
Acta Metall Sin  2010, Vol. 46 Issue (6): 674-680    DOI: 10.3724/SP.J.1037.2009.00846
论文 Current Issue | Archive | Adv Search |
THE RELAXATION PHENOMENON DURING MELT SUPERHEATING TREATMENT OF DZ125 ALLOY
WANG Changshuai; ZHANG Jun; ZOU Minming; LIU Lin; FU Hengzhi
State Key Laboratory of Solidification Processing; Northwestern Polytechnical University; Xi’an 710072
Cite this article: 

WANG Changshuai ZHANG Jun ZOU Minming LIU Lin FU Hengzhi. THE RELAXATION PHENOMENON DURING MELT SUPERHEATING TREATMENT OF DZ125 ALLOY. Acta Metall Sin, 2010, 46(6): 674-680.

Download:  PDF(2480KB) 
Export:  BibTeX | EndNote (RIS)      
Abstract  

As a precipitation hardened unidirectionally solidified Ni-based superalloy, DZ125 has been extensively applied as structural materials in advanced aeroengine for gas turbine blades and vanes operating at elevated temperatures. The solidification microstructure of alloy plays an important role in determining the alloy's mechanical properties. For a given alloy, the thermal history of alloy melt has an obvious influence on the final solidification microstructure. However, previous researches mainly focused on melt superheating temperature. There are few investigations about the influence of the relaxation process of alloy melt on the solidification structure. In this paper, under the same conditions of processing parameters, e.g.,  olid/liquid interface temperature gradient, withdrawing velocity, by changing the melt holding time, the relaxation phenomenon during melt superheating treatment of DZ125 was investigated. The melt was superheated to 1650 ℃ and kept for 30 min, and then it was rapidly cooled down to 1500 ℃. In order to study the relaxation phenomenon during melt superheating treatment, the melt was held for 15, 30 and 60 min, respectively, and then was withdrawn into the Ga-In-Sn liquid metal bath at a rate of 50 μm/s. The results show that dendrite arm spacing, segregation ratios, size and morphology of γ' phase and γ+γ' eutectic did not change with the increase of the holding time when melt holding time was less than 30 min. But, when melt holding time was prolonged to 60 min, the dendrite arm spacing, γ+γ' eutectic and the size of γ' phase in interdendrite area increased, and the segregation becomes serious, but the γ' phase on dendrite trunk was lightly refined. The morphology of MC carbide mainly showed disconnected blocky and nodule, and unchanged with the prolongation of holding time. These changes in solidification structure should be primarily attributed to the influence of relaxation process on melt structure. When the melt holding time was less than 30 min, there was no evidently change in melt structure. But, further prolonging melt holding time to 60 min, the melt structure had obvious variation. This variation affected the solidification processing and finally solidification structure. Therefore, the variation of melt holding time resulted in the change of solidification structure.

Key words:  Ni-based superalloy      melt superheating treatment      relaxation      solidification structure     
Received:  18 December 2009     
Fund: 

Supported by National Natural Science Foundation of China (No.50931004), National Basic Research Program of China (Nos.2006CB605202 and 2010CB631202) and National High Technology Research and Development Program of China (No.2007AA03Z552)

URL: 

https://www.ams.org.cn/EN/10.3724/SP.J.1037.2009.00846     OR     https://www.ams.org.cn/EN/Y2010/V46/I6/674

[1] Li L, Overfelt R A. J Mater Sci, 2002; 37: 3521
[2] Gui Z L. Aviat Product Eng, 1995; 4: 12
(桂忠楼. 航空制造工程, 1995, 4: 12)
[3] Liu L, Huang T W, Zhang J, Fu H Z. Mater Lett, 2007; 61: 227
[4] Kolotukhin E V, Kuleshova E A, Baryshev E E, Tyagnov G V. Met Sci Heat Treat, 1995; 37: 222
[5] Zou M M, Zhang J, Liu L, Fu H Z. Acta Metall Sin, 2008; 44: 59
(邹敏明, 张军, 刘林, 傅恒志. 金属学报, 2008, 44: 59)
[6] Saucedo E, Rudolph P, Dieguez E. J Cryst Growth, 2008; 310: 2067
[7] Gu Z H, Wang H Y, Zheng N, Zha M, Jiang L L, Wang W, Jiang Q C. J Mater Sci, 2008; 43: 980
[8] Cao P, Qian M, Stjohn D H. Scr Mater, 2007; 56: 633
[9] Popel P S, Calvo–Dahlborg M, Dahlborg U. J Non–Cryst Solids, 2007; 353: 3243
[10] Yin F S, Sun X F, Li J G, Gun H R, Hu Z Q. Scr Mater, 2003; 48: 425
[11] Zhang J, Li B, Zou M M, Wang C S, Liu L, Fu H Z. J Alloys Compd, 2009; 484: 753
[12] Cai Y W, Fan X H, Li J G, Fu H Z. J Northwestern Polytech Univ, 1996; 14: 323
(蔡英文, 范新会, 李建国, 傅恒志. 西北工业大学学报, 1996; 14: 323)
[13] Mao X M, Fu H Z, Zhou Y H. J Northwestern Polytech Univ, 1985; 3: 11
(毛协民, 傅恒志, 周尧和. 西北工业大学学报, 1985; 3: 11)
[14] Volkert C A, Spaepen F. Mater Sci Eng, 1988; 97: 449
[15] Maslov V V, Lad’yanov V I, Ilinsky A G, Nosenko V K. J Phys Conf Ser, 2008; 98: 072007
[16] Adam G, Gibbs J H. J Chem Phys, 1965; 43: 139
[17] Fredriksson H, Fredriksson E. Mater Sci Eng, 2005; A413–414: 455
[18] Zou M M, Zhang J, Liu L, Fu H Z. Mater Sci Technol, 2008; 16: 86
(邹敏明, 张军, 刘林, 傅恒志. 材料科学与工艺, 2008; 16: 86)
[19] Chen G, Yu J W, Xie F Q, Fu H Z. Acta Metall Sin, 2001; 37: 488
(陈光, 俞建伟, 谢发勤, 傅恒志. 金属学报, 2001; 37: 488)
[20] Zhang J, Yang M, Wang C S, Liu L, Fu H Z. Foundry Technol, 2009; 9: 1108
(张军, 杨敏, 王常帅, 刘林, 傅恒志. 铸造技术, 2009; 9: 1108)
[21] Gunduz M, C¸ ad?rl? E. Mater Sci Eng, 2002; A327: 167
[22] Flemings M C. Metall Trans, 1974; 5: 2121
[23] Geng X G, Chen G, Fu H Z. Acta Metall Sin, 2002; 38:225
(耿兴国, 陈光, 傅恒志. 金属学报, 2002; 38: 225)
[24] Li R S. Non–Equilibrium Thermodynamics and Dissipation Structure. Beijing: Tsinghua Universsity Press, 1986:55
(李如生. 非平衡态热力学和耗散结构. 北京: 清华大学出版社, 1986: 55)
[25] Yin F S, Sun X F, Guan H R, Hu Z Q. J Alloys Compd, 2004, 364: 225

[1] MA Dexin, ZHAO Yunxing, XU Weitai, WANG Fu. Effect of Gravity on Directionally Solidified Structure of Superalloys[J]. 金属学报, 2023, 59(9): 1279-1290.
[2] ZHENG Liang, ZHANG Qiang, LI Zhou, ZHANG Guoqing. Effects of Oxygen Increasing/Decreasing Processes on Surface Characteristics of Superalloy Powders and Properties of Their Bulk Alloy Counterparts: Powders Storage and Degassing[J]. 金属学报, 2023, 59(9): 1265-1278.
[3] MU Yahang, ZHANG Xue, CHEN Ziming, SUN Xiaofeng, LIANG Jingjing, LI Jinguo, ZHOU Yizhou. Modeling of Crack Susceptibility of Ni-Based Superalloy for Additive Manufacturing via Thermodynamic Calculation and Machine Learning[J]. 金属学报, 2023, 59(8): 1075-1086.
[4] ZHANG Lu, YU Zhiwei, ZHANG Leicheng, JIANG Rong, SONG Yingdong. Thermo-Mechanical Fatigue Cycle Damage Mechanism and Numerical Simulation of GH4169 Superalloy[J]. 金属学报, 2023, 59(7): 871-883.
[5] LIU Laidi, DING Biao, REN Weili, ZHONG Yunbo, WANG Hui, WANG Qiuliang. Multilayer Structure of DZ445 Ni-Based Superalloy Formed by Long Time Oxidation at High Temperature[J]. 金属学报, 2023, 59(3): 387-398.
[6] GUO Dongwei, GUO Kunhui, ZHANG Fuli, ZHANG Fei, CAO Jianghai, HOU Zibing. A New Method for CET Position Determination of Continuous Casting Billet Based on the Variation Characteristics of Secondary Dendrite Arm Spacing[J]. 金属学报, 2022, 58(6): 827-836.
[7] CAO Jianghai, HOU Zibing, GUO Zhongao, GUO Dongwei, TANG Ping. Effect of Superheat on Integral Morphology Characteristics of Solidification Structure and Permeability in Bearing Steel Billet[J]. 金属学报, 2021, 57(5): 586-594.
[8] ZHANG Nizhen, MA Xindi, GENG Chuan, MU Yongkun, SUN Kang, JIA Yandong, HUANG Bo, WANG Gang. Effect of Adding Ag on the Nanoindentation Behavior of Cu-Zr-Al-Based Metallic Glass[J]. 金属学报, 2021, 57(4): 567-574.
[9] JIANG Minqiang, GAO Yang. Structural Rejuvenation of Metallic Glasses and Its Effect on Mechanical Behaviors[J]. 金属学报, 2021, 57(4): 425-438.
[10] ZHU Yuping, Naicheng SHENG, XIE Jun, WANG Zhenjiang, XUN Shuling, YU Jinjiang, LI Jinguo, YANG Lin, HOU Guichen, ZHOU Yizhou, SUN Xiaofeng. Precipitation Behavior of W-Rich Phases in a High W-Containing Ni-Based Superalloys K416B[J]. 金属学报, 2021, 57(2): 215-223.
[11] ZHANG Zhuang, LI Haiyang, ZHOU Lei, LIU Huasong, TANG Haiyan, ZHANG Jiaquan. As-Cast Spot Segregation of Gear Steel and Its Evolution in the Rolled Products[J]. 金属学报, 2021, 57(10): 1281-1290.
[12] ZHANG Xiaoli, FENG Li, YANG Yanhong, ZHOU Yizhou, LIU Guiqun. Influence of Secondary Orientation on Competitive Grain Growth of Nickel-Based Superalloys[J]. 金属学报, 2020, 56(7): 969-978.
[13] LI Gen, LAN Peng, ZHANG Jiaquan. Solidification Structure Refinement in TWIP Steel by Ce Inoculation[J]. 金属学报, 2020, 56(5): 704-714.
[14] ZHANG Beijiang,HUANG Shuo,ZHANG Wenyun,TIAN Qiang,CHEN Shifu. Recent Development of Nickel-Based Disc Alloys andCorresponding Cast-Wrought Processing Techniques[J]. 金属学报, 2019, 55(9): 1095-1114.
[15] JIANG He,DONG Jianxin,ZHANG Maicang,YAO Zhihao,YANG Jing. Stress Relaxation Mechanism for Typical Nickel-Based Superalloys Under Service Condition[J]. 金属学报, 2019, 55(9): 1211-1220.
No Suggested Reading articles found!