Please wait a minute...
金属学报  2012, Vol. 48 Issue (6): 687-695    DOI: 10.3724/SP.J.1037.2012.00033
  论文 本期目录 | 过刊浏览 |
霉菌对裸铜和镀金处理的印制电路板腐蚀行为的影响
邹士文1,李晓刚1,2,董超芳1,2,李慧艳1,肖葵1,2
1. 北京科技大学腐蚀与防护中心, 北京 100083
2. 北京科技大学腐蚀与防护教育部重点实验室, 北京 100083
EFFECT OF MOLD ON CORROSION BEHAVIOR OF PRINTED CIRCUIT BOARD-COPPER AND ENIG FINISHED
ZOU Shiwen1, LI Xiaogang1,2, DONG Chaofang1,2,LI Huiyan1, XIAO Kui1,2
1. Corrosion and Protection Center, University of Science and Technology Beijing, Beijing 100083
2. Key Laboratory of Corrosion and Protection, Ministry of Education, University of Science and Technology Beijing,Beijing 100083
引用本文:

邹士文,李晓刚,董超芳,李慧艳,肖葵. 霉菌对裸铜和镀金处理的印制电路板腐蚀行为的影响[J]. 金属学报, 2012, 48(6): 687-695.
, , , , . EFFECT OF MOLD ON CORROSION BEHAVIOR OF PRINTED CIRCUIT BOARD-COPPER AND ENIG FINISHED[J]. Acta Metall Sin, 2012, 48(6): 687-695.

全文: PDF(4804 KB)  
摘要: 采用扫描Kelvin探针测试技术研究了裸铜印制电路板(PCB--Cu)和无电镀镍金处理印制电路板(PCB-ENIG)在霉菌作用下的腐蚀行为, 通过体视学显微镜、扫描电镜和能谱分析对PCB的腐蚀和霉菌生长情况进行了观察和分析. 结果表明, 在湿热环境下霉菌在2种材料表面均能良好生长并且数量逐渐增加, 28 d完成一个生长代谢周期且分生孢子活性良好; 84 d后试样表面都出现了腐蚀产物, PCB--ENIG腐蚀更为严重. 霉菌的生长代谢作用在一定程度上能抑制PCB--Cu表面霉菌生长区域的腐蚀, 但是对PCB--ENIG的微孔腐蚀起促进作用.
关键词 霉菌印制电路板扫描Kelvin探针Cu, 镀金处理    
Abstract:With the development of miniaturization of electronic circuits and occurrence of growing number of project failure cases, the corrosion behavior of printed circuit board (PCB) becomes a non-ignorable scientific issue under the hygrothermal condition with mold. In this paper, the corrosion behavior of unfinished PCB (PCB-Cu) and PCB finished by electroless nickel immersion gold (PCB--ENIG) in mold environment was studied using scanning Kelvin probe (SKP). The mold growth behavior was observed by stereo microscope and SEM, and the corrosion products were analyzed by EDS. The results showed that the number of mold increased on the surface of PCB-Cu and PCB-ENIG specimens under hygrothermal condition. After a growth cycle of 28 d, the new generation of conidium formed with good activity. After 84 d mold test, corrosion occurred on both two kinds of specimens and it was more severe on PCB--ENIG. Meanwhile the activity of mold was an inhibitor in the corrosion process of PCB--Cu and a promoter in the pore corrosion process of PCB-ENIG.
Key wordsmold    printed circuit board    scanning Kelvin probe    copper    electroless nickel immersion gold
收稿日期: 2012-01-13     
ZTFLH: 

TG172.4

 
基金资助:

中国航空科学基金项目2011ZD74003和中央高校基本科研业务费FRF--TP--11--006B资助

作者简介: 邹士文, 男, 1986年生, 博士生
[1] Huang H L, Dong Z H, Chen Z Y, Guo X P.  Corros Sci, 2011; 53: 1230

[2] Chen D M, Li J G, Su X R, Yang G.  Equip Environ Eng, 2006; 3: 78

    (陈丹明, 李金国, 苏兴荣, 杨光. 装备环境工程, 2006; 3: 78)

[3] Fang H H P, Xu L C, Chan K Y.  Water Res, 2002; 36: 4709

[4] Klintworth R, Reher H J, Viktorov A N, Bohle D.  Acta Astronaut, 1999; 44: 569

[5] Liu X F, Chen G M, Wang H G.  Corros Sci Prot Technol, 2004; 16: 318

    (刘晓方, 陈桂明, 王汉功. 腐蚀科学与防护技术, 2004; 16: 318)

[6] Zhang J Y.  Mater Prot, 2007; 40: 59

    (张继源. 材料保护, 2007; 40: 59)

[7] Sun H L, Wang X H.  Equip Environ Eng, 2008; 5: 49

     (孙海龙, 王晓慧. 装备环境工程, 2008; 5: 49)

[8] Liang Z Y, Lin Y S, Ye D Z, Yao R M.  Acta Oceanol Sin, 1986; 8: 251

    (梁子原, 林燕顺, 叶德赞, 姚瑞梅. 海洋学报, 1986; 8: 251)

[9] Juzeliunas E, Ramanauskas R, Lugauskas A, Samuleviciene A, Leinartas K. Electrochem Commun, 2005; 7: 305

[10] Juzeliunas E, Ramanauskas R, Lugauskas A, Leinartas K, Samuleviciene M, Sudavicius A, Juskenas R. Corros Sci, 2007; 49: 4098

[11] Huang H L, Guo X P, Zhang G A, Dong Z H.  Corros Sci, 2011; 53: 1700

[12] Zhang S N, Osterman M, Shrivastava A, Kang R, Pecht M G. IEEE Trans Device Mater Relia, 2010; 10: 71

[13] Gen W Y, Chen X, Hu A M.  Microelectron Rel, 2011; 51: 866

[14] Zhao P, Pecht M.  Microelectron Rel, 2003; 43: 775

[15] Kleber Ch, Wiesinger R, Schnoller J, Hilfrich U, Hutter H, Schreiner M.  Corros Sci, 2008; 50: 1112

[16] Tran T T M, Fiaud C, Sutter E M M.  Corros Sci, 2005; 47: 1724

[17] Simeon J K.  IEEE T Mater Pack, 1969; 5: 89

[18] Sun A C, Moffat H K, Enos D G, Glauner C S.  IEEE Trans Compon Pack T, 2007; 30: 796

[19] Russo S G, Henderson M J, Hinton B R W.  Eng Fail Anal, 2002; 9: 423

[20] Morozova E V, Baranova M V, Kozlov V P, Tereshina V M, Memorskaya A S, Feofilova E P. Microbiology, 2001; 70: 527

[21] Abarca M L, Accensi F, Cano J, Cabanes F J.  Antonie van Leeuwenhoek, 2004; 86: 33

[22] Wang L W, Du C W, Liu Z Y, Zeng X X, Li X G.  Acta Metall Sin, 2011; 47: 1227

     (王力伟, 杜翠薇, 刘智勇, 曾笑笑, 李晓刚. 金属学报, 2011; 47: 1227)

[23] Stratmann M, Streckel H, Bunsen B.  Phys Chem, 1988; 92: 1244

[24] Sun M, Xiao K, Dong C F, Li X G, Zhong P.  Acta Metall Sin, 2011; 47: 442

     (孙敏, 肖葵, 董超芳, 李晓刚, 钟平. 金属学报, 2011; 47: 442)

[25] Ambat R, Mφller P.  Corros Sci, 2007; 49: 2866

[26] Trethewey K P, Chamberlain J.  Corrosion for Science and Engineering.Beijing: World Publishing Corporation, 2000: 84
 
 
[1] 丁康康, 肖葵, 邹士文, 董超芳, 赵瑞涛, 李晓刚. PCB-HASL电路板在NaHSO3/Na2SO3溶液中的腐蚀电化学行为[J]. 金属学报, 2014, 50(10): 1269-1278.
[2] 生海,董超芳,肖葵,李晓刚. 高强铝合金裂纹尖端在3.5NaCl溶液中的微区电化学特性[J]. 金属学报, 2012, 48(4): 414-419.
[3] 孙敏 肖葵 董超芳 李晓刚 钟平. 带腐蚀产物超高强度钢的电化学行为[J]. 金属学报, 2011, 47(4): 442-448.