Please wait a minute...
金属学报  2004, Vol. 40 Issue (2): 141-147     
  论文 本期目录 | 过刊浏览 |
原始晶粒尺寸对低碳钢中铁素体动态再结晶的影响
李龙飞;杨王玥;孙祖庆
北京科技大学材料科学与工程学院; 北京 100083
Effect of Initial Grain Size on Dynamic Recrystallization of Ferrite in
LI Longfei; YANG Wangyue;SUN Zuqing
School of Materials Science & Engineering; University of Science
引用本文:

李龙飞; 杨王玥; 孙祖庆 . 原始晶粒尺寸对低碳钢中铁素体动态再结晶的影响[J]. 金属学报, 2004, 40(2): 141-147 .
, , . Effect of Initial Grain Size on Dynamic Recrystallization of Ferrite in[J]. Acta Metall Sin, 2004, 40(2): 141-147 .

全文: PDF(11487 KB)  
摘要: 采用Gleeble1500型热模拟试验机进行单轴热压缩实验, 研究了4种不同原始晶粒尺寸的低碳钢在变形温度为700 和600 ℃, 应变速率为10 1--10 3 s-1条件下的变形特性 及组织演变规律, 探讨了原始晶粒尺寸和热加工参数Z$值 对铁素体动态再结晶过程的影响. 结果表明: 在本实验变 形条件范围内, 4种不同原始晶粒尺寸的低碳钢均可发生铁 素体动态再结晶, 原始晶粒尺寸的减小, 不但在恒定$Z$值条 件下有利于动态再结晶过程的进行, 而且使铁素体可以发生 动态再结晶的临界Z值和发生不连续动态再结晶的临界Z值均 增大. 形变强化相变生成的细小铁素体晶粒在热变形时易于 发生动态再结晶, 只要控制好热加工参数, 可以利用动态再 结晶过程, 进一步细化形变强化相变生成的铁素体晶粒.
关键词 铁素体动态再结晶 低碳钢    
Abstract:The hot deformation behavior and the microstructure evolution of a low carbon steel with different initial grain sizes are investigated by uniaxial hot compression at deformation temperatures of 700 ℃ and 600 ℃ and strain rates of 10 s-1 to 10-3 s-1. The effect of initial grain size and hot deformation parameter Z on dynamic recrystallization of ferrite is approached. The results indicate that under the present deformation conditions, the dynamic recrystallization of ferrite takes place in the low carbon steel. The decrease of initial grain size is not only of benefit to the dynamic recrystallization of ferrite at a certain Z value, but also leads to the increase of the critical values of Z for both the dynamic recrystallization of ferrite and the discontinuous dynamic recrystallization of ferrite. It is suggested that the fine ferrite formed by deformation enhanced transformation is beneficial to the occurrence of dynamic recrystallization of ferrite during hot deformation. Further refinement of the fine ferrite can be realized by the dynamic recrystallization of ferrite under a suitable Z value.
Key wordsdynamic recrystallization of ferrite    low carbon steel   
收稿日期: 2003-02-24     
ZTFLH:  TG111.7  
[1] Sun Z Q, Yang W Y, Qi J J, Hu A M. Mater Sci Eng, 2002; 334A: 201
[2] Sakai T, Jonas J J. Acta Metall, 1984; 32: 189
[3] Li L F, Yang W Y, Sun Z Q. Acta Metall Sin, 2003; 39: 419(李龙飞,杨王玥,孙祖庆.金属学报, 2003; 39: 419)
[4] Yang W Y, Wang H M, Li L F, Sun Z Q. Acta Metall Sin, 2003; 39: 691(杨王玥,王红梅,李龙飞,孙祖庆.金属学报,2003;39:691)
[5] Glover G, Sellars C M. Metall Trans, 1973; 4: 765
[6] Tsuji N, Matsubara Y, Saito Y. Scr Mater, 1997; 37: 477
[7] Tsuji N, Matsubara Y, Saito Y, Maki T. J Jpn Inst Met, 1998; 62: 967((?)伸泰,松原行宏,斋藤好弘,牧正志.日本金属学会志,1998;62:967)
[8] Gao F, Xu Y, Song B, Xia K. Metall Mater Trans, 2000; 31A: 21
[9] Li L F, Yang W Y, Sun Z Q, Wang Q F. J Univ Sci Technol Beijing, 2001; 23: 225(李龙飞,杨王玥,孙祖庆,王青峰.北京科技大学学报,2001;23:225)
[1] 李小涵, 曹公望, 郭明晓, 彭云超, 马凯军, 王振尧. 低碳钢Q235、管线钢L415和压力容器钢16MnNi在湛江高湿高辐照海洋工业大气环境下的初期腐蚀行为[J]. 金属学报, 2023, 59(7): 884-892.
[2] 彭治强, 柳前, 郭东伟, 曾子航, 曹江海, 侯自兵. 基于大数据挖掘的连铸结晶器传热独立变化规律[J]. 金属学报, 2023, 59(10): 1389-1400.
[3] 刘灿帅,田朝晖,张志明,王俭秋,韩恩厚. 地质处置低氧过渡期X65低碳钢腐蚀行为研究[J]. 金属学报, 2019, 55(7): 849-858.
[4] 王大伟,修世超. 焊接温度对碳钢/奥氏体不锈钢扩散焊接头界面组织及性能的影响[J]. 金属学报, 2017, 53(5): 567-574.
[5] 文怀梁, 董俊华, 柯伟, 陈文娟, 阳靖峰, 陈楠. 模拟高放废物地质处置环境下重碳酸盐浓度对低碳钢活化/钝化腐蚀倾向的影响*[J]. 金属学报, 2014, 50(3): 275-284.
[6] 穆鑫, 魏洁, 董俊华, 柯伟. 牺牲阳极保护对Q235B钢在模拟海洋潮差区间腐蚀行为的影响[J]. 金属学报, 2014, 50(11): 1294-1304.
[7] 傅欣欣, 董俊华, 韩恩厚, 柯伟. 低碳钢Q235在模拟酸雨大气腐蚀条件下的电化学阻抗谱监测*[J]. 金属学报, 2014, 50(1): 57-63.
[8] 谭向虎,单际国,任家烈. Cr层对低碳钢/CFRP激光连接接头剪切强度及界面结合特征的影响[J]. 金属学报, 2013, 49(6): 751-756.
[9] 陈高,高子英. 焊接工艺参数对低碳钢CO2激光深熔焊接气孔形成的影响[J]. 金属学报, 2013, 49(2): 181-186.
[10] 侯自勇 许云波 吴迪. 超快速退火下超低碳钢的再结晶行为研究[J]. 金属学报, 2012, 48(9): 1057-1066.
[11] 任勇强 谢振家 尚成嘉. 低碳钢中残余奥氏体的调控及对力学性能的影响[J]. 金属学报, 2012, 48(9): 1074-1080.
[12] 穆鑫,魏洁,董俊华,柯伟. 低碳钢在模拟海洋潮差区的腐蚀行为的电化学研究[J]. 金属学报, 2012, 48(4): 420-426.
[13] 许恒栋 赵海燕 S¨orn Ocylok Igor Kelbassa. 低碳钢表面激光直接镀Ti层中裂纹形成的研究[J]. 金属学报, 2012, 48(2): 142-147.
[14] 张朋 张福成 王天生. 渗碳20CrMnMoAl钢表面硬贝氏体的制备及其组织特征[J]. 金属学报, 2011, 47(8): 1038-1045.
[15] 阳靖峰 董俊华 柯伟 陈楠. 硼酸缓冲溶液中pH值和腐蚀产物对低碳钢活化/钝化敏感性的影响[J]. 金属学报, 2011, 47(2): 152-156.