Please wait a minute...
金属学报  2009, Vol. 45 Issue (7): 826-829    
  论文 本期目录 | 过刊浏览 |
室温下20钢高周次单轴棘轮行为的实验研究
董亚伟;  康国政; 刘宇杰; 王弘; 程晓娟
(西南交通大学力学与工程学院; 成都 610031)
EXPERIMENTAL STUDY ON UNIAXIAL RATCHETING OF 20 STEEL WITH HIGH NUMBER OF CYCLES AT ROOM TEMPERATURE
DONG Yawei; KANG Guozheng; LIU Yujie; WANG Hong; CHENG Xiaojuan
School of Mechanics and Engineering; Southwest Jiaotong University; Chengdu 610031
引用本文:

董亚伟 康国政 刘宇杰 王弘 程晓娟. 室温下20钢高周次单轴棘轮行为的实验研究[J]. 金属学报, 2009, 45(7): 826-829.
, , , , . EXPERIMENTAL STUDY ON UNIAXIAL RATCHETING OF 20 STEEL WITH HIGH NUMBER OF CYCLES AT ROOM TEMPERATURE[J]. Acta Metall Sin, 2009, 45(7): 826-829.

全文: PDF(803 KB)  
摘要: 

通过对20钢的单轴应变控制循环和应力控制循环实验研究, 揭示了20钢在室温下的循环变形特性, 讨论了材料的循环软/硬化特性和材料的屈服平台以及平均应力、应力幅值和应力比对材料高周次棘轮行为的影响. 研究表明: 20钢表现出弱的、与应变幅值相关的循环硬化特性; 其棘轮行为依赖于平均应力、应力幅值和应力比的大小, 在高应力水平时的高周次循环后期, 棘轮变形会出现<再次增长的现象; 材料的屈服平台对棘轮行为有明显的影响, 在对20钢的棘轮行为进行本构描述时需要加以合理考虑.

关键词 20钢棘轮行为屈服平台室温单轴加载    
Abstract

Ratcheting is a cyclic accumulation of inelastic strain occurred under the stress--controlled cyclic loading with< non--zero mean stress, it is very important in assessing the fatigue life and safety of the structure subjected to cyclic loading. The existed results showed that different materials presented different ratcheting features, and the results were obtained from the cyclic tests with a small number of cycles (less than 200 cyc). Therefore, based on the uniaxial strain--controlled and stress--controlled cyclic tests with high number of cycles (more than 2000 cyc), the cyclic deformation features of 20 steel were observed at room temperature. The effects of the cyclic softening/hardening feature and yielding plateau of the steel and the applied mean stress, stress amplitude and stress ratio on the ratcheting of the steel with high number of cycles were studied. The results show that the 20 steel presents a weak and stain--amplitude--dependent cyclic hardening, and the ratcheting of the steel depends greatly on the applied mean stress, stress amplitude and stress ratio. The ratcheting strain increases monotonically with the increase of applied mean stress and stress amplitude, but decreases with the increase of stress ratio. A re--speeded ratcheting will occur at the end of cycling with high number of cycles when the applied stress levels are high enough. More importantly, the yielding plateau of the steel greatly influences the evolution of the ratcheting. It is concluded that the effect of yielding plateau on the ratcheting should be reasonably considered in constructing the cyclic constitutive model of the ratcheting for the 20 steel.

Key words20 steel    ratcheting behavior    yielding plateau    room temperature    uniaxial loading
收稿日期: 2008-11-17     
ZTFLH: 

O344.1

 
基金资助:

国家自然科学基金资助项目10772153

作者简介: 董亚伟, 男, 1984年生, 硕士生

[1] Ohno N. Mater Sci Res Int, 1997; 3: 1
[2] Bari S, Hassan T. Int J Plast, 2002; 18: 873
[3] Chen X, Jiao R. Int J Plast, 2004; 20: 871
[4] Chen X, Jiao R, Kim K S. Int J Plast, 2005; 21: 161
[5] Kang G Z. Int J Fatigue, 2008; 30: 1448
[6] Kang G Z, Sun Y F, Zhang J, Kan Q H. Acta Metall Sin, 2005; 41: 277
(康国政, 孙亚芳, 张娟, 阚前华. 金属学报, 2005; 41: 277)

[7] Kan Q H, Kang G Z, Zhang J, Liu Y J. Acta Metall Sin, 2005; 41: 963
(阚前华, 康国政, 张娟, 刘宇杰. 金属学报, 2005; 41: 963)

[8] Kang G Z, Liu Y J. Acta Metall Sin, 2006; 42: 59
(康国政, 刘宇杰. 金属学报, 2006; 42: 59)

[9] Lissenden C J, Doraiswamy D, Arnold S M. Int J Plast, 2007; 23: 1
[10] Chen G, Chen X, Kim K S, Abdel–Karim M, Sakane M. J Electron Packag, 2007; 129: 278
[11] Kang G Z, Liu Y J, Li Z. Mater Sci Eng, 2006; A435–436: 396
[12] Kang G Z, Liu Y J, Ding J. Int J Fatigue, 2008; 30: 2104
[13] Kwofie S, Chandler H D. Int J Fatigue, 2007; 29: 2117
[14] Satyadevi A, Sivakumar S M, Bhattacharya S S. Mater Sci Eng, 2007; A452–453: 380
[15] Kang G Z, Liu Y J. Mater Sci Eng, 2008; A472: 258

[1] 耿遥祥,特古斯,汪海斌,董闯,王宇鑫. Sn的加入对MnFe(P, Si)合金显微组织和磁性的影响[J]. 金属学报, 2017, 53(1): 77-82.
[2] 杨亮,高叔博,王艳丽,叶腾,宋霖,林均品. Si对高Nb-TiAl合金组织及室温拉伸性能的影响*[J]. 金属学报, 2015, 51(7): 859-865.
[3] 李小龙, 郭正洪, 戎咏华, 吴海洋, 姚圣法. 基于屈服平台理论开发的600 MPa级高强塑性螺纹钢的研究*[J]. 金属学报, 2014, 50(4): 439-446.
[4] 朱春雷, 李胜, 李海昭, 张继. 750 ℃热暴露对定向层片组织铸造TiAl合金室温拉伸塑性的影响[J]. 金属学报, 2014, 50(12): 1478-1484.
[5] 李海昭,张继. Al含量对高Nb铸造TiAl合金高温强度和室温塑性的影响[J]. 金属学报, 2013, 49(11): 1423-1427.
[6] 崔崇亮,朱天龙,冷哲,巫瑞智,张景怀,张密林. 复合添加Y和Nd对Mg-Li合金显微组织及室温压缩织构的影响[J]. 金属学报, 2012, 48(6): 725-732.
[7] 高茜 孙本哲 祁阳 齐连仲. 溶胶--凝胶法制备的Zn1-xCoxO晶体粉末的结构和磁性行为[J]. 金属学报, 2011, 47(3): 337-343.
[8] 王华 史文 何燕霖 符仁钰 李麟. Mn和P在超低碳烘烤硬化钢中的分布形态及对其拉伸行为的影响研究[J]. 金属学报, 2011, 47(3): 263-268.
[9] 聂德福 赵杰 张俊善. 一种估算结构钢室温蠕变的方法[J]. 金属学报, 2011, 47(2): 179-184.
[10] 张桂凯 李炬 陈长安 窦三平 凌国平. HR--2不锈钢表面渗Al涂层的制备[J]. 金属学报, 2009, 45(8): 983-987.
[11] NIE Defu ZHAO Jie. 相续室温蠕变中屈服强度附近的应力应变行为[J]. 金属学报, 2009, 45(7): 840-843.
[12] 季刚; 张云鹏; 颜世申; 梅良模; 张泽 . 氧分压对Zn 1-xCo xO 1-δ磁性半导体磁特性的调控作用[J]. 金属学报, 2008, 44(11): 1399-1403 .
[13] 郭素娟; 康国政 . SiCp/6061Al合金复合材料循环变形行为的有限元模拟[J]. 金属学报, 2006, 42(10): 1051-1055 .
[14] 康国政; 刘宇杰 . SiCp/6061Al合金复合材料的单轴循环变形行为及其时间相关特性[J]. 金属学报, 2006, 42(1): 59-66 .
[15] 康国政; 孙亚芳; 张娟; 阚前华 . SS304不锈钢在室温单轴循环加载下的时相关棘轮行为[J]. 金属学报, 2005, 41(3): 277-281 .