|
|
EMBRITTLEMENT OF Fe-Cr-Al ALLOYS AND EFFECT OF YTTRIUM ADDITION |
LI Bei; WU Shuangxia; LI Dianchen (Baotou Research Institute of Rare Earth; Ministry of Metallurgical Industry); MA Ruzhang (University of Science and Technology Beijing) |
|
Cite this article:
LI Bei; WU Shuangxia; LI Dianchen (Baotou Research Institute of Rare Earth; Ministry of Metallurgical Industry); MA Ruzhang (University of Science and Technology Beijing). EMBRITTLEMENT OF Fe-Cr-Al ALLOYS AND EFFECT OF YTTRIUM ADDITION. Acta Metall Sin, 1992, 28(10): 29-35.
|
Abstract A high temperature embrittlement occures in Fe-15Cr-4Al and Fe-20Cr-41Al alloys treated over 1000℃. It is caused mainly by 475℃ brittleness during cooling. When a secondary treatment at 500℃ was conducted, the 475℃ brittleness developed very rapidly. After only 15 min of the treating, little plasticity was remained for all samples pretreated at the temperatures over 1000℃ and cooled in water. However, no 475℃ brittleness was generated when pretreating temperature was below 1000℃ . Addition of Yttrium can inhibit not only grain growth, but also 475℃ brittleness. For the alloys with 0.2 —0.4wt-%Y, after treating at 800—1300℃, the plasticity did not decrease and the properties of furnace cooled samples were not lower than those of water cooled samples.
|
Received: 18 October 1992
|
1 肖纪美.不锈钢的金属学问题.北京:冶金工业出版社,1983 2 杜国维,杜永良,章小雁.北京钢铁学院学报,1988;10:368 3 Li Bei, Yan Yuxin, Meng Guang'en, Wu Shuangxia, Tang Fenghuang. Chin J Met Sci Technol, 1991; 7: 40 4 李碚,吴双霞.钢铁,待发表 5 徐祖耀.相变原理.北京:科学出版社,1988% |
No Suggested Reading articles found! |
|
|
Viewed |
|
|
|
Full text
|
|
|
|
|
Abstract
|
|
|
|
|
Cited |
|
|
|
|
|
Shared |
|
|
|
|
|
Discussed |
|
|
|
|