金属学报  1978, Vol. 14 Issue (3): 292-338

论文 本期目录 | 过刊浏览 |

铜对低碳镇静钢冷轧薄板再结晶织构的影响

周永忻;黄清珠;陈乾惕;邓定庆;蒲绍康

武汉钢铁公司钢铁研究所;武汉钢铁公司钢铁研究所;武汉钢铁公司钢铁研究所;武汉钢铁公司钢铁研究所;武汉钢铁公司钢铁研究所

EFFECT OF COPPER ON THE RECRYSTALLIZATION TEXTURE OF COLD ROLLED LOW CARBON STEEL SHEET

Zhou Yong-xin Huang Qing-zhu Chen Qian-ti Deng Ding-qing Pu Shao-kang(Research Institute of Wuhan Iron and Steel Company)

周永忻;黄清珠;陈乾惕;邓定庆;蒲绍康. 铜对低碳镇静钢冷轧薄板再结晶织构的影响[J]. 金属学报, 1978, 14(3): 292-338.
, , , , . EFFECT OF COPPER ON THE RECRYSTALLIZATION TEXTURE OF COLD ROLLED LOW CARBON STEEL SHEET[J]. Acta Metall Sin, 1978, 14(3): 292-338.

摘要 参考文献 相关文章 Metrics 全文: PDF(1376 KB)   摘要: 研究了铜对含铜低碳铝镇静钢再结晶织构的影响,含铜量为0—0.355％,试样为1.0毫米厚的冷轧薄板。 采用X射线极点密度测量、塑性应变比测量及金相腐蚀坑方法,证明随含铜量的增加,对深冲性能有利的{111}织构组元增强,尤其当含铜量超过固溶度时更为显著。 在含铜0.355％的样品中,用透射电子显微镜观察到细小的ε-Cu相在位错线附近析出。ε-Cu相的析出被认为是{111}织构增强的原因。 Abstract：The recrystallization texture of cold-rolled low-carbon steel sheets containing copper up to 0.355% has been studied by means of X-ray pole density measurement, plastic strain ratio measurement and metallographic etching-pit technique. It is shown that the {111} texture component, which is beneficial to the deep-drawing ability, appears to be enhanced with increasing copper content, especially when the copper content exceeds the limit of solubility. Fine precipitates of ε-Cu phase around dislocation in specimens containing 0.355% Cu have been observed by transmission electron microscopy. The presence of such precipitates may be regarded as the cause of the enhancement of the {111} texture component. 收稿日期: 1978-03-18      服务 把本文推荐给朋友 加入引用管理器 E-mail Alert RSS 作者相关文章 周永忻 黄清珠 陈乾惕 邓定庆 蒲绍康 44.8K 链接本文: https://www.ams.org.cn/CN/      或      https://www.ams.org.cn/CN/Y1978/V14/I3/292 [1] 大橋延夫,川畸制鉄技報,5(1973) ,№ 2,164． [2] Rickett, R. L. and Leslie, W. C., Trans. Amer. Soc. Metals, 51 (1959) , 310． [3] Leslie, W. C., Trans. AIME, 221 (1961) , 752． [4] Wacquez, P. and Van Daele, R., Sheet Metal Ind., 44 (1967) , № 477, 21． [5] 清水峰男,鉄鋼,58(1972) ,№ 4,S.267． [6] 须藤正俊,橋本俊一,铁鋼,58(1972) ,№ 11,S.476． [7] 稻垣裕辅,铁鋼,59(1973) ,№ 4,S.198． [8] 小西元幸,鉄鋼,59(1973) ,№ 4,S.200． [9] 阿部秀夫,铁鋼,59(1973) ,№ 4,S.199． [10] 阿部秀夫,鉄鋼,60(1974) ,217． [11] 阿部秀夫鈴木竹四,鉄鋼,60(1974) ,№ 11,S.487． [12] 金子輝雄,寺畸富久長,日本特開昭50-75114,(1975) . [13] Guimaraes, J. R. C. et al., Metallography, 9 (1976) , 1． [14] Mould, P. R. and Gray, J. M., Met. Trans., 3 (1972) , 3121． [15] Strassburger, C., Stahl Eisen, 94 (1974) , 409． [16] Tassy-Betz, E. and J., Metallography, 7 (1974) , 91． [17] 野村伸吾,鉄鋼,61(1975) ,54． [18] Wriedt, H. A. and Darken, L. S., Trans. AIME, 218 (1960) , 30． No related articles found! Viewed Full text Abstract Cited   Shared      Discussed