Please wait a minute...
金属学报  1991, Vol. 27 Issue (1): 32-38    
  论文 本期目录 | 过刊浏览 |
持续滑移带的物理损伤效应对Al单晶体裂纹启裂的影响
翟同广;林实;潘祜;肖纪美
北京科技大学材料物理系;博士研究生北京100083;北京科技大学;北京科技大学;冶金工业部钢铁研究总院;北京科技大学
INFLUENCE OF PHYSICAL DAMAGE EFFECT OF PSB ON CRACK INITIATION IN Al SINGLE CRYSTAL
ZHAI Tongguang;LIN Shi;PAN Hu;XIAO Jimei University of Science and Technology Beijing
引用本文:

翟同广;林实;潘祜;肖纪美. 持续滑移带的物理损伤效应对Al单晶体裂纹启裂的影响[J]. 金属学报, 1991, 27(1): 32-38.
, , , . INFLUENCE OF PHYSICAL DAMAGE EFFECT OF PSB ON CRACK INITIATION IN Al SINGLE CRYSTAL[J]. Acta Metall Sin, 1991, 27(1): 32-38.

全文: PDF(1569 KB)  
摘要: 本文研究了在纯Al单晶样品的两个特殊面(包含动作Burgers矢量的S面和与Burgers矢量成最小夹角的T面)上由循环形变引起的裂纹启裂过程,疲劳试验结果表明,在循环形变过程中,S面上没有形成表面持续滑移带,但有很多微裂纹产生,裂纹较短,平均长度约为10μm,近似沿一个方向分布,与动作Burgers矢量垂直,而T面上裂纹的形貌大致与以前的工作相同。通过扫描超声显微镜观察,发现在S面上的疲劳损伤要比T面上的深得多,为此,作者提出了裂纹启裂的孔洞模型及持续滑移带形成模型。
关键词 疲劳损伤单晶体裂纹启裂持续滑移带超声显微镜    
Abstract:An investigation was made of the crack initiation by cyclic deforma-tion on the two special surfaces of pure Al single crystal. One is the tOp-surfaeccontaining the active Burger's vector, and the other is the top-surface formingthe smallest angle with the active Burger's vector. The fatigue test were performedat the constant resolved shear stress amplitude (5 Pa), zero mean stress. Expe-rimentel results show that many microcracks are initiated on the side-surface onwhich no PSB surface topographies are formed during cyclic deformation. Cracks onthe side-surface are short with mean length of about 10 μm and distributed appro-ximately in a similar direction, perpendicular to the active Burger's vector, whereason the top-surface cracks are not as obvious as those on the side-surface. Observa-tions by scanning acoustic microscopy show that the fatigue damage on the side-surface is much deeper than that on the top-surface. A model of crack nucleationby voiding, and of PSB formation is suggested.
Key wordsfatigue damage    single crystal    crack initiation    persistent slip band    acoustic microscope
收稿日期: 1991-01-18     
基金资助:国家自然科学基金资助课题
1 Mughrabi H, Wang R, Differt K et al. ASTM STP 811, 1983: 5
2 Mughrabi H. In: McQueen H J, Bailon J-P, Dickson J I et al. eds. Strength of Metals and Alloys (ICSMA7) , Vol. III, Proc 7th Int Conf on the Strength of Metals and Alloys, Montreal, Canada, 12--16 Augest, 1985, Oxford: Pergamon, 1986: 1917
3 Neumann P. In: Cahn R W. Haasen P eds. Fatigue, Physical Matallurgy, 3rd ed, New York: Elsevier Science, 1983: 1553
4 Brown L M. In: Ashby M F, Bullough R, Hartley C S et al. eds. Dislocation Modelling of Physical Systems, Proc Int Conf, Gainesville, Florida USA, 22--27 June, 1980, Oxford: Pergamon, 1981: 51
5 Essmann U, Goesele U, Mughrabi H. Philos Mag, 1981; A44: 405
6 Smith G C. Mater Sci Technol, 1986; 2: 881
7 Vorren O. Ryum N. Acta Metall, 1987; 35: 855
[1] 张哲峰, 刘睿, 张振军, 田艳中, 张鹏. 金属材料疲劳性能预测统一模型探索[J]. 金属学报, 2018, 54(11): 1693-1704.
[2] 郭巍巍,齐成军,李小武. 共轭和临界双滑移取向Cu单晶体疲劳位错结构的热稳定性研究*[J]. 金属学报, 2016, 52(6): 761-768.
[3] 王晓钢,姜潮,韩旭. Ni单晶体塑性应变的非均匀性与加工硬化*[J]. 金属学报, 2015, 51(12): 1457-1464.
[4] 郭巍巍,齐成军,李小武. 一个共面双滑移取向Cu单晶体疲劳位错结构的热稳定性研究[J]. 金属学报, 2013, 49(1): 107-114.
[5] 李小武 曹昕明 马超群. 含富Cr沉淀颗粒Fe--Cr合金单晶体的疲劳变形特征[J]. 金属学报, 2009, 45(7): 801-807.
[6] 张继旺 鲁连涛 沈训梁 衣鸿飞 张卫华. 基于塑性应变的变幅应力疲劳损伤评估方法[J]. 金属学报, 2009, 45(12): 1461-1465.
[7] 刘江涛 王中光 尚建库. [110]和[112]取向β-Sn单晶体的形变行为[J]. 金属学报, 2008, 44(12): 1409-1414.
[8] 张广平; 王中光 . 小尺度材料的疲劳研究进展[J]. 金属学报, 2005, 41(1): 1-8 .
[9] 朱荣; 李守新; 李勇; 李明扬; 晁月盛 . Cu单晶体驻留滑移带的形成与消失[J]. 金属学报, 2004, 40(5): 467-470 .
[10] 杨继红; 贾维平; 李守新 . [013]取向Cu单晶体在NaCl水溶液中腐蚀疲劳位错结构的观察[J]. 金属学报, 2004, 40(1): 99-102 .
[11] 吴细毛; 王中光; 李广义 . [112]-Cu-7Al单晶体循环形变行为Ⅰ.应变突发行为[J]. 金属学报, 1999, 35(8): 789-792 .
[12] 吴细毛; 王中光; 李广义 . [112]Cu-7Al单晶体循环形变行为 Ⅱ.循环形变特征[J]. 金属学报, 1999, 35(8): 793-795 .
[13] 李小武; 王中光; 李守新 . 循环变形铜单晶体的滞后回线形状变化与驻留滑移带的萌生[J]. 金属学报, 1999, 35(6): 594-599 .
[14] 李小武;王中光;李守新. [■12]双滑移取向铜单晶体的循环应变硬化及饱和[J]. 金属学报, 1998, 34(8): 864-869.
[15] 李小武;王中光;孙守光;吴世丁;李守新;李广义. [011]多滑移取向铜单晶体的循环形变行为──Ⅱ.表面滑移特征及形变带[J]. 金属学报, 1998, 34(5): 552-560.