Phase Field Study of the Diffusional Paths in Pearlite-Austenite Transformation
Received date: 2021-07-27
Revised date: 2021-11-23
Online published: 2021-12-24
Supported by
National Natural Science Foundation of China(51771100)
In the development of advanced steel, accurate and detailed knowledge about the kinetics of phase transformations and microstructure formation is critical. The critical issue in pearlite-austenite transformation is the consideration of diffusional paths of the alloy element. Simulation has been an available method to study the diffusion of alloy elements and the migration rate of the phase boundary in the complex morphological evolution of austenite growth. The isothermal pearlite-austenite transformations at 720 and 740oC in Fe-0.6%C-2%Mn (mass fraction) alloy were studied by phase-field methods based on MICRESS. At different temperatures, the effects of diffusional paths on the austenite transformation were discussed. To achieve a semiquantitative verification of the simulated results, the migration rates of the austenite/pearlite boundary at 720 and 740oC were estimated from the experimental kinetics curves by fitting the JMA equation. By measuring the Mn profile in austenite, the modes of the austenization at 720 and 740oC can be verified as partitioned local equilibrium (PLE) and non-partitioned local equilibrium (NPLE) modes. The heterogeneous distribution of Mn in austenite at 740oC can be observed with STEM-EDS. However, the homogenous distribution of Mn can be found near the pearlite/austenite boundary in austenite at 720oC. The cases considering the γ, α, and interface-diffusional paths were simulated by phase-field methods to compare with the migration rates of the austenite/pearlite boundary. Because carbon is an interstitial element in steel and has an interstitial diffusional mechanism, it can be speculated reasonably that the diffusion of C mainly proceeded in austenite and ferrite through the considerations of the atom-size of carbon and the experimental results. Phase-field methods were used to study Mn diffusion in the lamellar pearlite-austenite transformation. With the analysis of the experimental estimations, the interface-diffusional path was observed as the dominant path for the Mn diffusion. It is because the Mn atoms have greater diffusivity in interfaces than in γ or α-diffusional paths. Furthermore, the diffusional activation energy is closely related to the diffusivity of Mn at the interface. Moreover, compared with the γ-diffusional path, the diffusional flux of Mn in ferrite is much larger than that in austenite. Thus, it can be concluded that the contribution of the α-diffusional path to the migration rate of the pearlite/austenite boundary is larger than that of the γ-diffusional path. As a result, considering the α-diffusional path in the thermodynamics analysis under NPLE mode makes more sense. However, ignoring the interface- and α-diffusional path, which is different from the traditional cognition in PLE mode, will result in a magnitude error for the thermodynamics analysis.
LI Sai , YANG Zenan , ZHANG Chi , YANG Zhigang . Phase Field Study of the Diffusional Paths in Pearlite-Austenite Transformation[J]. Acta Metall Sin, 2023 , 59(10) : 1376 -1388 . DOI: 10.11900/0412.1961.2021.00306
| 1 | Xu Z Y, Jin X J, Zhang J H, et al. Phase Transformation in Materials [M]. Beijing: Higher Education Press, 2013: 110 |
| 徐祖耀, 金学军, 张骥华 等. 材料相变 [M]. 北京: 高等教育出版社, 2013: 110 | |
| 2 | Li J J, Andrew G, Liu W. Effects of austenitization and cooling rates on the microstructure in a hypereutectoid steel [J]. Acta Metall. Sin., 2013, 49: 583 |
| 李俊杰, Andrew G, 刘 伟. 奥氏体化与冷却速率对过共析钢组织的影响 [J]. 金属学报, 2013, 49: 583 | |
| 3 | Katsamas A I. A computational study of austenite formation kinetics in rapidly heated steels [J]. Surf. Coat. Technol., 2007, 201: 6414 |
| 4 | Nehrenberg A E. The growth of austenite as related to prior structure [J]. JOM, 1950, 2(1): 162 |
| 5 | Caballero F G, Capdevila C, De Andrés C G. Influence of pearlite morphology and heating rate on the kinetics of continuously heated austenite formation in a eutectoid steel [J]. Metall. Mater. Trans., 2001, 32A: 1283 |
| 6 | Enomoto M, Li S, Yang Z N, et al. Partition and non-partition transition of austenite growth from a ferrite and cementite mixture in hypo- and hypereutectoid Fe-C-Mn alloys [J]. Calphad, 2018, 61: 116 |
| 7 | Xia Y, Enomoto M, Yang Z G, et al. Effects of alloying elements on the kinetics of austenitization from pearlite in Fe-C-M alloys [J]. Philos. Mag., 2013, 93: 1095 |
| 8 | Azizi-Alizamini H, Militzer M, Poole W J. Austenite formation in plain low-carbon steels [J]. Metall. Mater. Trans., 2011, 42A: 1544 |
| 9 | Zeldovich V I, Frolova N Y, Kheifets A E, et al. Features of austenite formation in low-carbon steel during high speed heating induced by high-speed deformation [J]. Met. Sci. Heat Treat., 2020, 62: 315 |
| 10 | Hillert M, Nilsson K, Torndahl L E. Effect of alloying elements on the formation of austenite and dissolution of cementite [J]. J. Iron Steel Inst., 1971, 209: 49 |
| 11 | Mancini R, Budde C. Reaustenitisation in Fe-C steels revisited [J]. Acta Mater., 1999, 47: 2907 |
| 12 | Chae J Y, Jang J H, Zhang G H, et al. Dilatometric analysis of cementite dissolution in hypereutectoid steels containing Cr [J]. Scr. Mater., 2011, 65: 245 |
| 13 | Nishibata T, Hayashi K, Saito T, et al. Influence of morphology of cementite on kinetics of austenitization in the binary Fe-C system [J]. Mater. Trans., 2020, 61: 1740 |
| 14 | Fridberg J, Torndahl L E, Hillert M. Diffusion in iron [J]. Jernkontorets Ann., 1969, 153: 263 |
| 15 | Akbay T, Atkinson C. The influence of diffusion of carbon in ferrite as well as in austenite on a model of reaustenitization from ferrite/cementite mixtures in Fe-C steels [J]. J. Mater. Sci., 1996, 31: 2221 |
| 16 | Kapturkiewicz W, Fra? E, Burbelko A A. Computer simulation of the austenitizing process in cast iron with pearlitic matrix [J]. Mater. Sci. Eng., 2005, A413-414: 352 |
| 17 | Miyamoto G, Usuki H, Li Z D, et al. Effects of Mn, Si and Cr addition on reverse transformation at 1073K from spheroidized cementite structure in Fe-0.6mass% C alloy [J]. Acta Mater., 2010, 58: 4492 |
| 18 | Wu Y X, Wang L Y, Sun W W, et al. Austenite formation kinetics from multicomponent cementite-ferrite aggregates [J]. Acta Mater., 2020, 196: 470 |
| 19 | Li Y Q, He Y, Liu J H, et al. Phase transformation and microstructure evolution of pearlite heat-resistant steel during heating [J]. Mater. Sci. Technol., 2020, 36: 771 |
| 20 | Khan A R, Yu S F, Zubair M. Direct observation of austenite and pearlite formation in thermally simulated coarse grain heat-affected zone of pearlite railway steel [J]. J. Mater. Eng. Perform., 2021, 30: 497 |
| 21 | Li Z D, Miyamoto G, Yang Z G, et al. Kinetics of reverse transformation from pearlite to austenite in an Fe-0.6 mass pct C alloy and the effects of alloying elements [J]. Metall. Mater. Trans., 2011, 42A: 1586 |
| 22 | Yang Z N, Xia Y, Enomoto M, et al. Effect of alloying element partition in pearlite on the growth of austenite in high-carbon low alloy steel [J]. Metall. Mater. Trans., 2016, 47A: 1019 |
| 23 | Yang Z N, Enomoto M, Zhang C, et al. Transition between alloy-element partitioned and non-partitioned growth of austenite from a ferrite and cementite mixture in a high-carbon low-alloy steel [J]. Philos. Mag. Lett., 2016, 96: 256 |
| 24 | Chen L Q. Phase-field models for microstructure evolution [J]. Ann. Rev. Mater. Res., 2002, 32: 113 |
| 25 | Militzer M. Phase field modeling of microstructure evolution in steels [J]. Curr. Opin. Solid State Mater. Sci., 2011, 15: 106 |
| 26 | Nakajima K, Apel M, Steinbach I. The role of carbon diffusion in ferrite on the kinetics of cooperative growth of pearlite: A multi-phase field study [J]. Acta Mater., 2006, 54: 3665 |
| 27 | Steinbach I, Apel M. The influence of lattice strain on pearlite formation in Fe-C [J]. Acta Mater., 2007, 55: 4817 |
| 28 | Loginova I, Odqvist J, Amberg G, et al. The phase-field approach and solute drag modeling of the transition to massive γ→α transformation in binary Fe-C alloys [J]. Acta Mater., 2003, 51: 1327 |
| 29 | Huang C J, Browne D J, McFadden S. A phase-field simulation of austenite to ferrite transformation kinetics in low carbon steels [J]. Acta Mater., 2006, 54: 11 |
| 30 | Militzer M, Azizi-Alizamini H. Phase field modelling of austenite formation in low carbon steels [J]. Solid State Phenom., 2011, 172-174: 1050 |
| 31 | |
| 32 | Rudnizki J, B?ttger B, Prahl U, et al. Phase-field modeling of austenite formation from a ferrite plus pearlite microstructure during annealing of cold-rolled dual-phase steel [J]. Metall. Mater. Trans., 2011, 42A: 2516 |
| 33 | Zhang X, Shen G, Li C W, et al. Phase-field simulation of austenite reversion in a Fe-9.6Ni-7.1Mn (at.%) martensitic steel governed by a coupled diffusional/displacive mechanism [J]. Mater. Des., 2020, 188: 108426 |
| 34 | Tiaden J, Nestler B, Diepers H J, et al. The multiphase-field model with an integrated concept for modelling solute diffusion [J]. Physica, 1998, 115D: 73 |
| 35 | Li S, Yang Z N, Enomoto M, et al. Study of partition to non-partition transition of austenite growth along pearlite lamellae in near-eutectoid Fe-C-Mn alloy [J]. Acta Mater., 2019, 177: 198 |
| 36 | Yang Z N. Effects of alloying element partition and its interfacial segregation on the thermodynamics and kinetics of phase transformation in steels [D]. Beijing: Tsinghua University, 2017 |
| 杨泽南. 合金元素配分与偏聚对钢中相变热力学及动力学的影响 [D]. 北京: 清华大学, 2017 | |
| 37 | Karmazin L. Experimental study of the austenitization process of hypereutectoid steel alloyed with small amounts of silicon, manganese and chromium, and with an initial structure of globular cementite in a ferrite matrix [J]. Mater. Sci. Eng., 1991, A142: 71 |
| 38 | Gaude-Fugarolas D, Bhadeshia H K D H. A model for austenitisation of hypoeutectoid steels [J]. J. Mater. Sci., 2003, 38: 1195 |
| 39 | Roósz A, Gácsi Z, Fuchs E G. Isothermal formation of austenite in eutectoid plain carbon steel [J]. Acta Metall., 1983, 31: 509 |
| 40 | Chen R C, Zheng Z Z, Li N, et al. In-situ investigation of phase transformation behaviors of 300M steel in continuous cooling process [J]. Mater. Charact., 2018, 144: 400 |
| 41 | Haroun N A. Grain size statistics [J]. J. Mater. Sci., 1981, 16: 2257 |
| 42 | Yu Y N. Fundamentals of Material [M]. 2nd Ed., Beijing: Higher Education Press, 2012: 650 |
| 余永宁. 材料科学基础 [M]. 第2版. 北京: 高等教育出版社, 2012: 650 | |
| 43 | Sun W W, Wu Y X, Yang S C, et al. Advanced high strength steel (AHSS) development through chemical patterning of austenite [J]. Scr. Mater., 2018, 146: 60 |
| 44 | Speich G R, Demarest V A, Miller R L. Formation of austenite during intercritical annealing of dual-phase steels [J]. Metall. Mater. Trans., 1981, 12A: 1419 |
| 45 | Yu Y N. Principles of the Metallography [M]. 3rd Ed., Beijing: Metallurgical Industry Press, 2020: 530 |
| 余永宁. 金属学原理 [M]. 第3版. 北京: 冶金工业出版社, 2020: 530 |
/
| 〈 |
|
〉 |
