反应堆控制棒材料Ag-In-Cd合金的压缩蠕变行为

肖红星; 龙冲生; 陈乐; 梁波

doi:10.3724/SP.J.1037.2013.00247

金属学报 >

2013 , Vol. 49 >Issue 8: 1012 - 1016

DOI: https://doi.org/10.3724/SP.J.1037.2013.00247

论文

反应堆控制棒材料Ag-In-Cd合金的压缩蠕变行为

肖红星 ,
龙冲生 ,
陈乐 ,
梁波

展开

中国核动力研究设计院反应堆燃料及材料重点实验室, 成都 610041

肖红星, 男, 1983年生, 助理研究员

收稿日期: 2013-05-05

修回日期: 2013-05-28

网络出版日期: 2013-08-11

基金资助

国家核电重大专项资助项目2011ZX06004-016

收起

COMPRESSIVE CREEP BEHAVIOR OF REACTOR CONTROL ROD MATERIAL Ag-In-Cd ALLOY

XIAO Hongxing ,
LONG Chongsheng ,
CHEN Le ,
LIANG Bo

Expand

Science and Technology on Reactor Fuel and Materials Laboratory, NuclearPower Institute of China, Chengdu 610041

Received date: 2013-05-05

Revised date: 2013-05-28

Online published: 2013-08-11

Fold

摘要

研究了铸态Ag-In-Cd合金在300—400℃及12—24 MPa压应力范围内的压缩蠕变行为,根据实验结果计算了表观应力指数n和表观激活能Q_a, 探讨了合金的压缩蠕变机制.结果表明, 随温度和应力的升高, 合金的稳态蠕变速率增加,稳态蠕变速率与应力之间呈指数关系. 温度为300, 350和400℃时, 合金的$n$分别为2.90, 4.09和5.77;压应力为12, 18和24 MPa时, 合金的Q_a值分别为68.1, 103.7和131.6 kJ/mol.位错运动形成大量层错是Ag-In-Cd合金在温度为300—400℃, 压应力为12—24 MPa下的压缩蠕变控制机制.

关键词： Ag-In-Cd合金; 压缩蠕变; 层错

本文引用格式

肖红星 , 龙冲生 , 陈乐 , 梁波 . 反应堆控制棒材料Ag-In-Cd合金的压缩蠕变行为[J]. 金属学报, 2013 , 49(8) : 1012 -1016 . DOI: 10.3724/SP.J.1037.2013.00247

Abstract

Ag-In-Cd alloy is widely used as the control rod material in the pressure water reactor (PWR),so it is very important to research the compressive creep behavior for understanding the mechanical property of control rod materials in pile. The compressive creep behavior of as-cast Ag-In-Cd alloy was investigated using a special apparatus at 300—400℃ and under compressive stresses in the range of 12—24 MPa in this work. The stress exponent n and apparent activation energy Q_a of the creep process have been calculated as well as the mechanisms of compressive creep behavior have been discussed. The results show that the compressive creep of the alloy increases with the increase of temperature and compressive stress. The relationship between steady creep rate and stress can be expressed in a power law form. The stress exponent n are 2.90, 4.09 and 5.77 at 300, 350 and 400℃ respectively. The apparent activation energy Q_a of the creep process are 68.1, 103.7 and 131.6 kJ/mol under compressive stresses of 12, 18 and 24 MPa respectively. Stacking fault is the primary rate controlling mechanism for the Ag-In-Cd alloy at 300—400℃ and the compressive stress range of 12—24 MPa, which was deduced from TEM observation.

Key words： Ag-In-Cd alloy; compressive creep; stacking fault

参考文献

[1] Bourgoin J, Couvreur F, Gosset D, Defoort F, Monchanin M, Thibault X. J Nucl Mater,1999; 275: 296

[2] Xue S J, Chen Y, Qiu S Y. Nucl Power Eng, 2004; 25: 522
(薛淑娟, 陈勇, 邱绍宇. 核动力工程, 2004; 25: 522)
[3] Devan K, Riyas A, Alagan M, Mohanakrishnan P. Ann Nucl Energy, 2008; 35: 1484
[4] Sepold L, Lind T, Pinter C A, Stegmaier U, Steinbruck M,
Stuckert J. Ann Nucl Energy, 2009; 36: 1349
[5] Amir H F, Saeed S. Prog Nucl Energy, 2009; 51: 184
[6] Mousavi S S A, Aghanajafi C, Sadoughi S, Sharifloo N. Ann Nucl Energy,2010; 37: 1659
[7] Dubourg R, Austregesilo H, Bals C, Barrachin M. Prog Nucl Energy, 2010; 52: 97
[8] Tian S G, Zhang J H, Jin T, Yang H C, Xu Y B, Hu Z Q. Acta Metall Sin, 1999; 35: 392
(田素贵, 张静华, 金涛, 杨洪才, 徐永波, 胡壮麒. 金属学报, 1999; 35: 392)

[9] Sha Y H, Zuo L, Zhang J H, Xu Y B, Hu Z Q. Acta Metall Sin, 2011; 37: 1142

(沙玉辉, 左良, 张静华, 徐永波, 胡壮麒. 金属学报, 2011; 37: 1142)

[10] Wei S H, Chen Y G, Tang Y B. Liu H M, Xiao S F, Niu G, Zhang X P, Zhao Y H. Mater Sci Eng, 2008; A492: 20
[11] Huang C, Yu X H, Yamabe M Y, Nakazawa S, Harada H. Mater Lett, 2003; 57: 3371
[12] Wei S H, Chen Y G, Tang Y B, Liu M, Xiao S F, Zhang X P, Zhao Y H. Trans Nonferrous Met Soc, 2008; 18: 214
[13] Wei X W, Shen B L. Mater Sci Technol, 2004; 12: 642
(魏晓伟, 沈保罗. 材料科学与工艺, 2004; 12: 642)
[14] Ren W L, Guo J T, Zhou J Y. Acta Metall Sin, 2002; 38: 908
(任维丽, 郭建亭, 周继扬. 金属学报, 2002; 38: 908)
[15] Fu X W, Yang W L, Zhang L Q. Acta Metall Sin, 2002; 38: 731
(傅晓伟, 杨王朗, 张来启. 金属学报, 2002; 38: 731)
[16] Pekguleryuz M O, Kaya A A. Adv Eng Mater, 2003; 5: 866
[17] Zeng M, Xu D F, Shen B L. Mater Heat Treat, 2008; 37: 17
(曾明, 徐道芬, 沈保罗. 材料热处理技术, 2008; 37: 17)
[18] Liu X Y, Pan Q L, Lu Z L, Cao S F, He Y B, Li W B. Acta Metall Sin, 2011; 47: 53
(刘晓艳, 潘清林, 陆智伦, 曹素芳, 何运斌, 李文斌. 金属学报, 2011; 47: 53)
[19] Xu C M. Guo J T. Acta Metall Sin, 2003; 39: 809
(徐春梅, 郭建亭. 金属学报, 2003; 39: 809)
[20] Weetman J. J Appl Phys, 1957; 28: 362
[21] Coble R L. J Appl Phys, 1963; 34: 1679
[22] Sherby O D, Burke P M. Prog Mater Sci, 1968; 13: 325
[23] Cannon W R, Sherby O D. Metall Trans, 1970; 1: 1030
[24] Luo A A. Int Mater Rev, 2004; 49: 13
[25] Yan J L, Sun Y S, Xue F. Acta Metall Sin, 2008; 44: 1354
(晏井利, 孙扬善, 薛烽. 金属学报, 2008; 44: 1354)
[26] Wei S H, Chen Y G, Tang Y B, Zhang X P, Liu M, Xiao S F, Zhao Y H. Mater Sci Eng, 2009; A508: 59

Options

文章导航

模态框（Modal）标题

摘要

本文引用格式

Abstract

参考文献