|
|
Martensitic Transformation and Damping Behavior of Ti70-xTa15Zr15Fex (x=0.3, 0.6, 1.0) Shape Memory Thin Films |
ZHENG Xiaohang1, NING Rui1, DUAN Jiatong2, CAI Wei1() |
1 Institue of Materials Science and Engineering, Harbin Institute of Technology, Harbin 150006, China 2 Center of Science and Technology, China Academy of Engineering Physics, Mianyang 621900, China |
|
Cite this article:
ZHENG Xiaohang, NING Rui, DUAN Jiatong, CAI Wei. Martensitic Transformation and Damping Behavior of Ti70-xTa15Zr15Fex (x=0.3, 0.6, 1.0) Shape Memory Thin Films. Acta Metall Sin, 2020, 56(12): 1690-1696.
|
Abstract In recent years, there has been a rapid development in microelectromechanical systems owing to their lightweight and integration with small volume. The microactuater bears low-frequency vibrations during operations, which affects the safety and stability of the device. Ti-Ta-Zr-Fe thin film is a high-temperature shape memory alloy film, which has good shape memory effect and thermal stability. The addition of Fe can improve the plasticity of the film and make it promising to use in high-temperature miniature damping devices. Ti70-xTa15Zr15Fex (x=0.3, 0.6, and 1.0, atomic fraction, %) shape memory thin films were prepared by direct-current magnetron sputtering. The effect of the Fe content on the microstructures, martensitic transformation, mechanical properties, and damping behavior was studied by XRD, TEM, bending test, and dynamic mechanical analysis. It was found that the room-temperature phase composition of the alloy films with different Fe contents were in the parent and martensite phases. The reverse martensitic transformation temperature of the thin films was above 100 ℃, and the films exhibited the two-way shape memory effect. The addition of Fe enhanced the ductility and strength of the film. When the Fe content was 1.0%, the elongation could reach up to 12.8%. During the heating and cooling processes, the relaxation type friction peak was observed. The damping capacity during the relaxation processof the film containing 1.0%Fe could reach up to 0.116.
|
Received: 11 May 2020
|
|
Fund: National Natural Science Foundation of China(51971083);National Natural Science Foundation of China(51731005) |
[1] |
Otsuka K, Wayman C M. Shape Memory Materials [M]. Cambridge: Cambridge University Press, 1999: 246
|
[2] |
Otsuka K, Ren X. Physical metallurgy of TiNi-based shape memory alloys [J]. Prog. Mater Sci., 2005, 50: 511
doi: 10.1016/j.pmatsci.2004.10.001
|
[3] |
Xu Z Y. Shape memory materials [J]. Trans. Nonferrous Met. Soc., 2001, 11: 1
|
[4] |
Miyazaki S, Fu Y Q, Huang W M. Thin Film Shape Memory Alloys: Fundamentals and Device Applications [M]. Cambridge: Cambridge University Press, 2009: 437
|
[5] |
Fu Y Q, Huang W M, Du H J, et al. Characterization of TiNi shape-memory alloy thin films for MEMS applications [J]. Surf. Coat. Technol., 2001, 145: 107
doi: 10.1016/S0257-8972(01)01324-X
|
[6] |
Wilson S A, Jourdain R P J, Zhang Q, et al. New materials for micro-scale sensors and actuators: An engineering review [J]. Mater. Sci. Eng., 2007, R56: 1
|
[7] |
Fu Y Q, Du H J, Huang W M, et al. TiNi-based thin films in MEMS applications: A review [J]. Sens. Actuators, 2004, 112A: 395
|
[8] |
Shin D D, Mohanchandra K P, Carman G P. Development of hydraulic linear actuator using thin film SMA [J]. Sens. Actuators, 2005, 119A: 151
|
[9] |
Fu Y Q, Luo J K, Flewitt A J, et al. Microactuators of free-standing TiNiCu films [J]. Smart Mater. Struct., 2007, 16: 2651
doi: 10.1088/0964-1726/16/6/070
|
[10] |
Winzek B, Schmitz S, Rumpf H, et al. Recent developments in shape memory thin film technology [J]. Mater. Sci. Eng., 2004, A378: 40
|
[11] |
Kim H Y, Mizutani M, Miyazaki S. Crystallization process and shape memory properties of Ti-Ni-Zr thin films [J]. Acta Mater., 2009, 57: 1920
doi: 10.1016/j.actamat.2008.12.036
|
[12] |
König D, Zarnetta R, Savan A, et al. Phase transformation, structural and functional fatigue properties of Ti-Ni-Hf shape memory thin films [J]. Acta Mater., 2011, 59: 3267
doi: 10.1016/j.actamat.2011.01.066
|
[13] |
Zheng X H, Sui J H, Zhang X, et al. Thermal stability and high-temperature shape memory effect of Ti-Ta-Zr alloy [J]. Scr. Mater., 2013, 68: 1008
doi: 10.1016/j.scriptamat.2013.03.008
|
[14] |
Zheng X H, Sui J H, Zhang X, et al. Effect of Y addition on the martensitic transformation and shape memory effect of Ti-Ta high-temperature shape memory alloy [J]. J. Alloys Compd., 2012, 539: 144
doi: 10.1016/j.jallcom.2012.06.021
|
[15] |
Wang C H, Liu M, Hu P F, et al. The effects of α″ and ω phases on the superelasticity and shape memory effect of binary Ti-Mo alloys [J]. J. Alloys Compd., 2017, 720: 488
doi: 10.1016/j.jallcom.2017.05.299
|
[16] |
Zheng X H, Sui J H, Yang Z Y, et al. Effect of thermo-mechanical process on structure and high temperature shape memory properties of Ti-15Ta-15Zr alloy [J]. Chin. Phys., 2017, 26B: 056103
|
[17] |
Bellouard Y. Shape memory alloys for microsystems: A review from a material research perspective [J]. Mater. Sci. Eng., 2008, A481-482: 582
|
[18] |
Zhang F, Cui Y, Xue P F, et al. Microstructures and memory properties of Ti69Zr30Fe1 high-temperature shape memory alloy [J]. Rare Met. Mater. Eng., 2013, 42: 2131
|
|
(张 菲, 崔 琰, 薛鹏飞等. Ti69Zr30Fe1高温形状记忆合金的微观结构和记忆特性 [J]. 稀有金属材料与工程, 2013, 42: 2131)
|
[19] |
Motemani Y, Buenconsejo P J S, Craciunescu C, et al. High-temperature shape memory effect in Ti-Ta thin films sputter deposited at room temperature [J]. Adv. Mater. Inter., 2014, 1: 1400019
doi: 10.1002/admi.201400019
|
[20] |
Ning R, Zheng X H, Yao J, et al. The effect of annealing treatment on microstructure and shape memory behavior of Ti-Ta-Zr thin films [J]. Vacuum, 2018, 153: 1
doi: 10.1016/j.vacuum.2018.03.044
|
[21] |
Buensconejo P J S, Kim H Y, Miyazaki S. Effect of ternary alloying elements on the shape memory behavior of Ti-Ta alloys [J]. Acta Mater., 2009,57: 2509
doi: 10.1016/j.actamat.2009.02.007
|
[22] |
Hsu H C, Hsu S K, Wu S C, et al. Structure and mechanical properties of as-cast Ti-5Nb-xFe alloys [J]. Mater. Charact., 2010, 61: 851
doi: 10.1016/j.matchar.2010.05.003
|
[23] |
Zheng P Q, Kucza N J, Patrick C L, et al. Mechanical and magnetic behavior of oligocrystalline Ni-Mn-Ga microwires [J]. J. Alloys Compd., 2015, 624: 226
doi: 10.1016/j.jallcom.2014.11.067
|
[24] |
Meng X L, Cai W, Wang L M, et al. Microstructure of stress-induced martensite in a Ti-Ni-Hf high temperature shape memory alloy [J]. Scr. Mater., 2001, 45: 1177
doi: 10.1016/S1359-6462(01)01147-2
|
[25] |
Yin F, Iwasaki S, Ping D, et al. Snoek-type high-damping alloys realized in β-Ti alloys with high oxygen solid solution [J]. Adv. Mater., 2006, 18: 1541
doi: 10.1002/(ISSN)1521-4095
|
[26] |
Wang Q, He Q X, Wang T, et al. Influence of solution-aging treatment on damping and tensile properties of Ti-36Nb-2Ta-3Zr-0.3O alloy [J]. Mater. Sci. Technol. 2019, 35: 37
doi: 10.1080/02670836.2018.1534717
|
[27] |
Segui C, Cesari E, Pons J, et al. Internal friction behaviour of Ni-Mn-Ga [J]. Mater. Sci. Eng., 2004, A370: 481
|
[28] |
Fan G, Zhou Y, Otsuka K, et al. Effects of frequency, composition, hydrogen and twin boundary density on the internal friction of Ti50Ni50-xCux shape memory alloys [J]. Acta Mater., 2006, 54: 5221
doi: 10.1016/j.actamat.2006.06.018
|
No Suggested Reading articles found! |
|
|
Viewed |
|
|
|
Full text
|
|
|
|
|
Abstract
|
|
|
|
|
Cited |
|
|
|
|
|
Shared |
|
|
|
|
|
Discussed |
|
|
|
|