Please wait a minute...
金属学报  1998, Vol. 34 Issue (12): 1289-1294    
  论文 本期目录 | 过刊浏览 |
DZ40M钴基高温合金950℃长期时效后的组织与性能
姜文辉;姚向东;管恒荣;胡壮麒
中国科学院金属研究所;沈阳;110015;沈阳工业大学;沈阳;110023;中国科学院金属研究所;沈阳;110015;中国科学院金属研究所;沈阳;110015;中国科学院金属研究所;沈阳;110015
MICROSTRUCTURES AND PROPERTIES OF DZ40M Co-BASE SUPERALLOY AFTER LONG-TERM AGEING AT 950℃
JIANG Wenhuil; YAO Xiangdong; GUAN Hengrong;HU Zhuangqi(Institute of Metal research; The Chinese Academy of Sciences; Shenyang 11O015)(Shenyang Polytechnic University; Shenyang 110023)Correspondent:JIANG Wenhui; Tel: (0U)2384353l-556o8; Fax: (024)23891320Manuscript received 1997-12-16; in revised form 1998-03-10
全文: PDF(2768 KB)  
摘要: 研究了新近开发的一种定向凝固钴基高温合金DZ40M950℃长期时效后的组织与性能.结果表明,合金时效后室温强度提高,塑性降低980℃,83MPa持久性能提高,而816℃,215MPa持久性能下降.在时效过程中,初生碳化物M7C3和MC缓慢分解,细小的M23C6在基体中大量析出,M6C在一些M7C3表面生成.分析认为,合金性能变化主要归因于M(23)C6沉淀析出初生碳化物M7C3和MC分解,释放出碳原子,促进M(23)C6沉淀反应、M6C形成是由于钨的局部偏聚所致.
关键词 钴基高温合金定向凝固时效碳化物转变力学性能    
Abstract:DZ40M, a newly developed directionally solidified Co-base superalloy was agedat 950℃ for long term. Its microstructural charateristics and mechanical properties at roomand elevated temperatures were studied. Long-term ageing results in substantial increase intensile strength and sharp reduction in ductility at room temperature. Its effect oil mechanicalprOPerties at elevated temperatures is dependent on eXperimental parameters. At 980℃ , 83 MPa,stress-rupture life is prolonged and at 816 ℃, 215 MPa, it is shortened. However, in all of thecases, the alloy possesses a high stress-rupture ductility. During ageing, primary carbide M7C3and MC decomposed sluggishly, fine M23C6 precipitated copiously around them and M6C formedon the surfaCe of some M7C3. Decomposition of the primary carbides promoted the precipitationof M23C6 by supplying carbon atoms and segregation of tungsten caused the precipitation ofM6C. It is thought that the change of mechanical properties of the alloy is attributed to theM23C6 precipitation.
Key wordsdirectional solidification    Co-base superalloy    ageing    carbide transformation    mechanical property
     出版日期: 1998-12-18

引用本文:

姜文辉;姚向东;管恒荣;胡壮麒. DZ40M钴基高温合金950℃长期时效后的组织与性能[J]. 金属学报, 1998, 34(12): 1289-1294.
JIANG Wenhuil; YAO Xiangdong; GUAN Hengrong;HU Zhuangqi(Institute of Metal research; The Chinese Academy of Sciences; Shenyang 11O015)(Shenyang Polytechnic University; Shenyang 110023)Correspondent:JIANG Wenhui; Tel: (0U)2384353l-556o8; Fax: (024)23891320Manuscript received 1997-12-16; in revised form 1998-03-10. MICROSTRUCTURES AND PROPERTIES OF DZ40M Co-BASE SUPERALLOY AFTER LONG-TERM AGEING AT 950℃. Acta Metall Sin, 1998, 34(12): 1289-1294.

链接本文:

http://www.ams.org.cn/CN/      或      http://www.ams.org.cn/CN/Y1998/V34/I12/1289

1管 恒荣,姚向东,张静华,张志亚,李英敖,胡壮麒.金属学报,1995;31(Suppl).):308(Guan H G, YaO X D, Zhang J H, Zhang Z Y, Li Y G, Hu Z Q. Acta Metall sin ,1995; 31(Suppl.): 3082姚向东,张静华,张志亚,李英敖,赵乃仁,管恒荣,胡壮麒.金属学报,1995;31:A32. (Yao X D,Zhang J H,Zhang Z y,Li Y G,ZHao N R,Guan H R,Hu Z Q.Acta Metall Sin.1995;31:A320)3 Tawancy H M,J Mater Sci, 1983; 18: 29764 Vandenousen R F,Viatour P.Drapier J M.Coutsouradis D.Cobalt.1974;(1):65 Sims C T.In:sims C T.Hagel W C eds.The Superalloys.New York:John Wiley & Sons Inc,1972:1546 Lane J R and Grant N J. 7YYI。 ASM, 1952; 44: 1137姚向东,张静华,张志亚,李英敖,管恒荣,胡壮麒.金属学报,1995;31(suppl):304(YaO X D, Zhang J H, Zhang Z Y, Li Y G, Guan H R, Hu Z Q. Acta Metall Sin, 1995; 31(Suppl.): 304)8Hamar-Thibault S, Durand-Charre M, Andries B. Metall Trans ,1982; 13A: 545
[1] 王晨充,张弛,杨志刚,苏杰,翁宇庆. 高Co-Ni二次硬化钢的设计准则与时效工艺分析[J]. 金属学报, 2017, 53(2): 175-182.
[2] 明洪亮,张志明,王俭秋,韩恩厚,苏明星. 国产核电安全端异种金属焊接件的微观结构及局部性能研究[J]. 金属学报, 2017, 53(1): 57-69.
[3] 王峰,马德志,王志,毛萍莉,刘正. AM50-x(Zn, Y)镁合金的显微组织、力学性能与凝固行为*[J]. 金属学报, 2016, 52(9): 1115-1122.
[4] 左锦荣,侯陇刚,史金涛,崔华,庄林忠,张济山. 两阶段轧制变形过程中高强铝合金析出相与晶粒结构演变及其对性能的影响*[J]. 金属学报, 2016, 52(9): 1105-1114.
[5] 黄文普,喻寒琛,殷杰,王泽敏,曾晓雁. 激光选区熔化成形K4202镍基铸造高温合金的组织和性能*[J]. 金属学报, 2016, 52(9): 1089-1095.
[6] 陈瑞,许庆彦,柳百成. Al-Mg-Si合金中针棒状析出相时效析出动力学及强化模拟研究*[J]. 金属学报, 2016, 52(8): 987-999.
[7] 骆良顺,刘桐,张延宁,苏彦庆,郭景杰,傅恒志. 定向凝固Al-Y合金组织演化规律及小平面相生长*I. Al-15%Y过共晶合金组织演化规律[J]. 金属学报, 2016, 52(7): 859-865.
[8] 刘桐,骆良顺,张延宁,苏彦庆,郭景杰,傅恒志. 定向凝固Al-Y合金组织演化规律及小平面相生长*II. Al-53%Y包晶合金组织演化规律[J]. 金属学报, 2016, 52(7): 866-874.
[9] 崔君军,陈礼清,李海智,佟伟平. 等温淬火低合金贝氏体球墨铸铁的回火组织与力学性能*[J]. 金属学报, 2016, 52(7): 778-786.
[10] 孙元,刘纪德,侯星宇,王广磊,杨金侠,金涛,周亦胄. DD5单晶高温合金大间隙钎焊的组织演变与界面形成机制*[J]. 金属学报, 2016, 52(7): 875-882.
[11] 于冰冰,陈志勇,赵子博,刘建荣,王清江,李晋炜. TC17钛合金电子束焊接接头的显微组织与力学性能研究*[J]. 金属学报, 2016, 52(7): 831-841.
[12] 孟帅举,余晖,张慧星,崔红卫,王志峰,赵维民. Bi添加对挤压纯Mg组织和力学性能的影响*[J]. 金属学报, 2016, 52(7): 811-820.
[13] 张思倩,王栋,王迪,彭建强. Re对一种定向凝固镍基高温合金微观组织的影响*[J]. 金属学报, 2016, 52(7): 851-858.
[14] 张京,郑运荣,冯强. 基于蠕变损伤的定向凝固DZ125合金恢复热处理研究*[J]. 金属学报, 2016, 52(6): 717-726.
[15] 钟华,李传军,王江,任忠鸣,钟云波,玄伟东. 强磁场对定向凝固Al-4.5Cu合金微观偏析的影响*[J]. 金属学报, 2016, 52(5): 575-582.