Please wait a minute...
金属学报  2011, Vol. 47 Issue (5): 634-640    DOI: 10.3724/SP.J.1037.2010.00552
  论文 本期目录 | 过刊浏览 |
间接超声振动制备5052铝合金半固态浆料
吕书林, 吴树森, 戴维, 安萍, 毛有武
华中科技大学材料成形与模具技术国家重点实验室, 武汉 430074
PREPARATION OF SEMISOLID 5052 ALUMINUM ALLOY SLURRY BY INDIRECT ULTRASONIC VIBRATION
LU Shulin, WU Shusen, DAI Wei, AN Ping, MAO Youwu
State Key Lab of Materials Processing and Die & Mould Technology, Huazhong University of Science and Technology, Wuhan 430074
引用本文:

吕书林 吴树森 戴维 安萍 毛有武. 间接超声振动制备5052铝合金半固态浆料[J]. 金属学报, 2011, 47(5): 634-640.
, , , , . PREPARATION OF SEMISOLID 5052 ALUMINUM ALLOY SLURRY BY INDIRECT ULTRASONIC VIBRATION[J]. Acta Metall Sin, 2011, 47(5): 634-640.

全文: PDF(1695 KB)  
摘要: 采用一种新型的间接超声振动装置制备5052铝合金半固态浆料, 研究了启振温度和振动时间对浆料组织的影响. 结果表明, 在液相线温度643℃及以上开始对5052铝合金熔体进行50 s的间接超声处理, 能获得晶粒细小圆整的半固态浆料. 在液相线温度开始通过杯底对合金熔体进行间接超声处理, 可在杯底附近大量形核, 随后初生晶粒以球状方式生长; 在60 s的制浆时间内, 晶粒平均直径先减小后增大, 平均形状系数则一直增大. 熔体温度降至液相线以下3℃时再进行间接超声处理, 亦能破碎发达的枝晶获得蔷薇状组织和球状晶粒共存的半固态浆料, 晶粒平均直径为105 μm.
关键词 间接超声振动初生晶粒空化效应半固态浆料    
Abstract:A new indirect ultrasonic vibration (IUV) apparatus was employed to prepare semisolid 5052 aluminum slurry. The effects of IUV temperature and time on the morphology of the semisolid slurry were studied. The results indicate that semisolid slurry with fine and globular primary grains can be obtained by applying IUV from the liquidus temperature (643℃) of this alloy or a higher temperature for about 50 s. When IUV is applied through the bottom of the metal cup at 643℃, a lot of nuclei form near the bottom of metal cup and these nuclei grow into globular grains. In this stage, the average diameter of primary grains decreases as IUV time increased up to 30 s and then it increases with further increasing of IUV time from 30 s to 60 s, and the average shape coefficient of primary grains increases as IUV time increased. When the IUV is applied at 640℃, dendrites can be broke up and a mixture structure consisted of rosette and globular grains with a average diameter of 105 μm is obtained.
Key wordsindirect ultrasonic vibration    primary grains    cavitation effect    semi-solid slurry
收稿日期: 2010-10-15     
基金资助:

国家自然科学基金项目50775086和国家高技术研究发展计划项目2007AA03Z557资助

作者简介: 吕书林, 男, 1982年生, 博士生
[1] Wu S S, Zhao J W, Zhang L P, An P, Mao Y W. Solid State Phenom, 2008; 141–143: 451

[2] Zhao JW,Wu S S, Wan L, Chen Q H, An P. Acta Metall Sin, 2009; 45: 314

(赵君文, 吴树森, 万里, 陈启华, 安 萍. 金属学报, 2009; 45: 314)

[3] Zhao JW,Wu S S, An P, Mao YW. Solid State Phenom, 2008; 141–143: 767

[4] Abramov V, Abramov O, Bulgakov V, Sommer F. Mater Lett, 1998; 37: 27

[5] Eskin G I, Eskin D G. Ultrason Sonochem, 2003; 10: 297

[6] Jian X, Xu H, Meek T T, Han Q. Mater Lett, 2005; 59: 190

[7] Gao D M, Li Z J, Han Q Y, Zhai Q J. Mater Sci Eng, 2009; A502: 2

[8] Liu Q M, Zhang Y, Song Y L, Qi F P, Zhai Q J. Mater Des, 2007; 28: 1949

[9] Kaibyshev R, Musin F, Lesuer D R, Nieh T G. Mater Sci Eng, 2003; A342: 169

[10] Piao L, Motegi T. J Jpn Inst Light Met, 2005; 55(2): 86

[11] Lu S L, Wu S S, Zhu Z M, An P, Mao Y W. Trans Nonferrous Met Soc China, 2010; 20: 758

[12] Lu S L, Wu S S, Dai W, Zhu Z M, Mao, Y W, Wan L. Spec Cast Nonferrous Alloys, 2010; 30: 326

(吕书林, 吴树森, 戴维, 朱泽明, 毛有武, 万 里. 特种铸造及有色合金, 2010; 30: 326)

[13] Liu C, Pan Y, Aoyama S. In: Bhasin A K, Moore J J, Young K P, Midson S, eds., Proc 5th Int Conf on Semi–solid Processing of Alloys and Composites, Colorado: Golden, 1998: 431

[14] Kapustina O A. The Physical Principles of Ultrasonic Manufactureing. Moscow: Nauka, 1970: 45

[15] Ohno A. Solidification: The Separation Theory and Its Practical Applications. Berlin: Springer, 1987: 1

[16] Qian M, Ramirez A, Das A. J Cryst Growth, 2009; 311: 3708

[17] Wu S S, Xie L Z, Zhao J W, Nakae H. Scr Mater, 2008; 58: 556

[18] Qian M, Ramirez A, Das A, Stjohn D H. J Cryst Growth, 2010; 312: 2267

[19] Taghavi F, Saghafian H, Kharrazi Y H K. Mater Des, 2009; 30: 115

[20] Campbell J. Int Mater Rev, 1981; 2: 71
[1] 赵君文 吴树森 万里 陈启华 安萍. 超声场中金属半固态浆料组织的演化[J]. 金属学报, 2009, 45(3): 314-319.
[2] 王平; 路贵民; 崔建忠 . 近液相线半连续铸造A356铝合金显微组织[J]. 金属学报, 2002, 38(4): 389-392 .